FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
1 | 1. | Button |
2 | 2. | Red indicator |
| 3. | Battery cartridge |
| 3 |
|
011755 |
|
|
•Always switch off the tool before installing or removing of the battery cartridge.
•To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge.
•To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red indicator on the upper side of the button, it is not locked completely. Install it fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you.
•Do not use force when installing the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly.
Battery protection system (Battery cartridge with a star mark)
1 | 1. Star mark |
011389 |
|
The battery cartridge with a star mark is equipped with the protection system, which automatically cuts off the output power for its long service life.
The tool stops during operation when the tool and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the tool trouble.
•When the tool is overloaded:
At this time, release the switch trigger, remove the battery cartridge and remove causes of overload and then pull the switch trigger again to restart.
•When battery cells get hot:
If any operation of the switch trigger, the motor will remain stopped. At this time, stop use of the tool and cool or charge the battery cartridge after removing it from the tool.
•When the remaining battery capacity gets low:
If any operation of the switch trigger, the motor will remain stopped. At this time, remove the battery cartridge from the tool and charge it .
Adjusting depth of cut
1 | 1. | Pointer | |
2. | Knob | ||
|
2
011737
Depth of cut may be adjusted by simply turning the knob on the front of the tool so that the pointer points the desired depth of cut.
Switch action
1 | 2 | 1. | |
2. | Switch trigger |
011738
CAUTION:
•Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.
•Do not pull the switch trigger hard without pressing the
To prevent the switch trigger from being accidentally pulled, a
6