VPOS | (OPS1200 Display and Keyboard Only) |
Move the vertical cursor position | |
Format: | VPOS {value} |
Group: | Character I/O |
Units: | none |
See also: | HPOS, OPEN |
This command allows moving the cursor on the LCD screen in the vertical direction. The value is a number from 0 to 3. The lines on the LCD screen are numbered from top to bottom as 0, 1, 2, and 3.
Note that this command will only work if the OPS: device has been opened using the “OPEN” command.
The following example sets the cursor position to the third LCD screen line:
Usage example:
VPOS 2
Chapter 2, OPS1200 Firmware Command Set | 17 |