Fluke 110 user manual Testing Diodes

Page 12

Models 110, 111 & 112

Users Manual

Testing Diodes

Good Diode				Good Diode

	Single Beep
Forward Bias	Reverse Bias
Bad Diode	Bad Diode

Measuring AC or DC CurrentW(Models 111 and 112)

Warning

To avoid personal injury or damage to the Meter:

∙Never attempt to make an in-circuit current measure-

ment when the open-circuit potential to earth is > 600 V.

∙Check the Meter's fuse before testing. (See “Testing the Fuse”)

∙Use the proper terminals, switch position, and range for your measurement.

∙Never place the probes in parallel with a circuit or component when the leads are plugged into the current terminals.

Turn power OFF, break circuit, insert Meter in series, turn power on.

A

A


and			aej08f.eps

Open

Shorted

aej07f.eps

8

Image 12

Contents Models 110, 111 Limited Warranty and Limitation of Liability Table of Contents Read Before Using the Meter Warnings and Precautions SymbolsModels 110, 111 Contacting Fluke Unsafe VoltageTest Lead Alert Switch Position TerminalsDescription Measurement FunctionTrue RMS Multimeters DisplayModels 110, 111 MIN MAX AVG Recording Mode Display Hold To avoid electric shock, when Display Hold isWhen you apply a different voltage Backlight Model 112 OnlyPower-Up Options Button Power-Up OptionsManual Ranging and Auto Ranging Models 110, 111 Making Basic Measurements Making Basic Measurements Testing Diodes Using the Bar Graph CleaningReplacing the Battery andWFuse Testing the Fuse ModelsW111Specifications Resolution Accuracy ± % of Reading + Counts Function Models 110, 111