Installation Instructions
Installation
The attenuators may be installed with or without the base. The base is removed by unscrewing the two fillister head screws from the bottom of the base. The attenuator may be mounted without the base by inserting two
The solenoid drive cable connector plug is connected to the attenuator by aligning the plug (Pl) with the jack (Jl) on the attenuator, and then pushing the plug over the jack. The plug is removed by grasping the ribbed sides of the plug and squeezing them together while pulling back until the plug clears the jack.
8494/95/96G/H Operating And Service Manual 11