Cisco Systems 3700 specifications Controller Layer 3 devices Cisco Aironet access points

Page 15

Figure 4 Pre-Installation Configuration Setup

Controller

Layer 3 devices

Cisco Aironet access points

272488

To perform pre-installation configuration, perform the following steps:

Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate Cisco wireless LAN controller guide.

a.Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management and AP-Manager Interface.

b.Configure the switch to which your access point is to attach. See the Cisco Wireless LAN Controller Configuration Guide, Release x.x for additional information.

c.Set the Cisco wireless LAN controller as the master so that new access points always join with it.

d.Make sure DHCP is enabled on the network. The access point must receive its IP address through DHCP.

e.CAPWAP UDP ports must not be blocked in the network.

f.The access point must be able to find the IP address of the controller. This can be accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP method to convey the controller IP address. For other methods, refer to the product

15

Image 15

Contents Cisco Aironet 3700 Series Access Points First Published November, 2013 Last Updated March 31 About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement Configurations UnpackingExternal Antennas Regulatory Domains Internal AntennasCountries Supported Access Point Ports and Connections top-3702E Model Access Point Ports and ConnectorsAccess Point LED Indicator top-3702I Model Controller Discovery Process Configuring the Access PointPage Preparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access points Page Deploying the Access Point on the Wireless Network Mounting the Access PointInstalling Modules Troubleshooting Using Dhcp OptionChecking the Access Point LED LED LED Show ap join stats detailed ap base radio MAC address Troubleshooting the Access Point Join ProcessPage Declarations of Conformity and Regulatory Information USA Vcci Statement for Japan 03-6434-6500 Industry Canada Canadian Compliance Statement Statement 371-Power Cable and AC AdapterFrench Translation Module Models Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves MPE Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCisco AP c3700 Cisco AP c3700-ServiceProvider Type + Length + Value Access Point Specifications Cisco Systems, Inc

Related manuals

Manual 18 pages 19.61 Kb

Manual 12 pages 45.34 Kb

Manual 12 pages 37.96 Kb

Manual 85 pages 32.54 Kb