Cisco Systems 3700 Mounting the Access Point, Deploying the Access Point on the Wireless Network

Page 17

Step 4 If the pre-installation configuration is successful, the Status LED is green indicating normal operation. Disconnect the access point and mount it at the location at which you intend to deploy it on the wireless network.

Step 5 If your access point does not indicate normal operation, turn it off and repeat the pre-installation configuration.

Note When you are installing a Layer 3 access point on a different subnet than the Cisco wireless LAN controller, be sure that a DHCP server is reachable from the subnet on which you will be installing the access point, and that the subnet has a route back to the Cisco wireless LAN controller. Also be sure that the route back to the Cisco wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP communications. Ensure that the route back to the primary, secondary, and tertiary wireless LAN controller allows IP packet fragments. Finally, be sure that if address translation is used, that the access point and the Cisco wireless LAN controller have

astatic 1-to-1 NAT to an outside address. (Port Address Translation is not supported.)

8Mounting the Access Point

Cisco Aironet 3702 series access points can be mounted in several configurations, including on a suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended ceiling. Click this URL to browse to complete access point mounting instructions:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/mounting/guide/apmount.html

9Deploying the Access Point on the Wireless Network

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Step 1 Connect and power up the access point.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Cisco Aironet 3700 Series Access Points First Published November, 2013 Last Updated March 31 About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement External Antennas ConfigurationsUnpacking Regulatory Domains Internal AntennasCountries Supported Access Point Ports and Connections top-3702E Model Access Point Ports and ConnectorsAccess Point LED Indicator top-3702I Model Controller Discovery Process Configuring the Access PointPage Preparing the Access Point Pre-Installation Configuration Setup Installation SummaryPerforming a Pre-Installation Configuration Controller Layer 3 devices Cisco Aironet access points Page Deploying the Access Point on the Wireless Network Mounting the Access PointInstalling Modules Checking the Access Point LED TroubleshootingUsing Dhcp Option LED LED Show ap join stats detailed ap base radio MAC address Troubleshooting the Access Point Join ProcessPage Declarations of Conformity and Regulatory Information USA Vcci Statement for Japan 03-6434-6500 Industry Canada Canadian Compliance Statement Statement 371-Power Cable and AC AdapterFrench Translation Module Models Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves MPE Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCisco AP c3700 Cisco AP c3700-ServiceProvider Type + Length + Value Access Point Specifications Cisco Systems, Inc
Related manuals
Manual 18 pages 19.61 Kb Manual 12 pages 45.34 Kb Manual 12 pages 37.96 Kb Manual 85 pages 32.54 Kb
Top Page Image Contents