Cisco Systems 3700 specifications 20A. Statement

Page 5

Warning

Warning

Warning

Warning

Caution

Caution

Note

Note

Installation of the equipment must comply with local and national electrical codes. Statement 1074

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:

20A. Statement 1005

Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless the device has been modified to be especially qualified for such use. Statement 245B

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332

The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.

This product and all interconnected equipment must be installed indoors within the same building, including the associated LAN connections as defined by Environment A of the IEEE 802.af Standard.

The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power injector in air handling spaces.

Use only with listed ITE equipment.

5

Image 5

Contents Cisco Aironet 3700 Series Access Points First Published November, 2013 Last Updated March 31 About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement External Antennas ConfigurationsUnpacking Regulatory Domains Internal AntennasCountries Supported Access Point Ports and Connections top-3702E Model Access Point Ports and ConnectorsAccess Point LED Indicator top-3702I Model Controller Discovery Process Configuring the Access PointPage Preparing the Access Point Pre-Installation Configuration Setup Installation SummaryPerforming a Pre-Installation Configuration Controller Layer 3 devices Cisco Aironet access points Page Deploying the Access Point on the Wireless Network Mounting the Access PointInstalling Modules Checking the Access Point LED TroubleshootingUsing Dhcp Option LED LED Show ap join stats detailed ap base radio MAC address Troubleshooting the Access Point Join ProcessPage Declarations of Conformity and Regulatory Information USA Vcci Statement for Japan 03-6434-6500 Industry Canada Canadian Compliance Statement Statement 371-Power Cable and AC AdapterFrench Translation Module Models Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves MPE Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCisco AP c3700 Cisco AP c3700-ServiceProvider Type + Length + Value Access Point Specifications Cisco Systems, Inc

Related manuals

Manual 18 pages 19.61 Kb

Manual 12 pages 45.34 Kb

Manual 12 pages 37.96 Kb

Manual 85 pages 32.54 Kb