Cisco Systems 3700 specifications Installing Modules

Page 18

Step 2 Observe the access point LED (for LED descriptions, see “Checking the Access Point LED” section on page 19).

a.When you power up the access point, it begins a power-up sequence that you can verify by observing the access point LED. If the power-up sequence is successful, the discovery and join process begins. During this process, the LED blinks sequentially green, red, and off. When the access point has joined a controller, the LED is green if no clients are associated or blue if one or more clients are associated.

b.If the LED is not on, the access point is most likely not receiving power.

c.If the LED blinks sequentially for more than 5 minutes, the access point is unable to find its primary, secondary, and tertiary Cisco wireless LAN controller. Check the connection between the access point and the Cisco wireless LAN controller, and be sure the access point and the Cisco wireless LAN controller are either on the same subnet or that the access point has a route back to its primary, secondary, and tertiary Cisco wireless LAN controller. Also, if the access point is not on the same subnet as the Cisco wireless LAN controller, be sure that there is a properly configured DHCP server on the same subnet as the access point. See the “Configuring DHCP Option 43 and DHCP Option 60” section on page 40 for additional information.

Step 3 Reconfigure the Cisco wireless LAN controller so that it is not the Master.

Note A Master Cisco wireless LAN controller should be used only for configuring access points and not in a working network.

10Installing Modules

Modules are devices that are purchased as separate items. When they are installed in the Cisco Aironet 3700 series access point, they give the access point additional capabilities.

Modules connect to the access point’s module port. No special tools are required to install a module.

For information on how to install a module, see the Installing and Removing Cisco Aironet Access Point Modules guide at the following URL:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/3600/module_install/11AC_WSM_modul es.html

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Cisco Aironet 3700 Series Access Points First Published November, 2013 Last Updated March 31 Introduction to the Access Point About this GuideSafety Instructions Important Safety Instructions20A. Statement Configurations UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported Access Point Ports and Connectors Access Point Ports and Connections top-3702E ModelAccess Point LED Indicator top-3702I Model Configuring the Access Point Controller Discovery ProcessPage Preparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access points Page Mounting the Access Point Deploying the Access Point on the Wireless NetworkInstalling Modules Troubleshooting Using Dhcp OptionChecking the Access Point LED LED LED Troubleshooting the Access Point Join Process Show ap join stats detailed ap base radio MAC addressPage Declarations of Conformity and Regulatory Information USA Vcci Statement for Japan 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry Canada Canadian Compliance StatementFrench Translation Module Models Page Page Declaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves MPE Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Declaration of Conformity Statements Portuguese TranslationCisco AP c3700 Cisco AP c3700-ServiceProvider Type + Length + Value Access Point Specifications Cisco Systems, Inc
Related manuals
Manual 18 pages 19.61 Kb Manual 12 pages 45.34 Kb Manual 12 pages 37.96 Kb Manual 85 pages 32.54 Kb
Top Page Image Contents