321 Studios 69488 Safety Warnings, Set up Precautions, Safety Setup Operation, Maintenance

Page 3

Important Safety Instructions

WARNING When using this product basic precautions should always be followed, including the following:

Safety Warnings

1.Read all the instructions before using the product.

2.To reduce the risk of injury, close supervision is necessary when a product is used near children.

3.Know how to stop the product and bleed pressures quickly. Be thoroughly familiar with the controls.

4.Stay alert – watch what you are doing.

5.Do not operate the product when fatigued or under the influence of medication, alcohol or drugs.

6.Keep operating area clear of all persons.

7.Do not overreach or stand on unstable support. Keep good footing and balance at all times.

8.Follow the maintenance instructions specified in the manual.

9.This product Is provided with A Ground Fault Circuit Interrupter (GFCI) built into the power cord plug. If replacement of the plug or cord is needed, use only identical replacement parts.

10.WARNING – Risk of injection or injury– do not direct discharge stream at persons.

11.Connect to individual branch circuit only.

12.WARNING – To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands.

13.Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the pressure washer. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.

14.GFCI Precautions

Test GFCI (Ground Fault Circuit Interrupter) before each use as follows:

a.Plug GFCI into power outlet and press reset button. Indicator should turn on.

b.Press test button. Indicator should turn off.

c.Press reset button again for use.

Do not use if above test fails.

The GFCI device does not protect against electrical shock due to contact with both circuit conductors or a fault in any wiring supplying the GFCI device.

To allow GFCI unit to function properly, extension cords must not be used with this pressure washer.

Set up Precautions

Safety

Setup

Operation

1.The work area should have adequate drainage to reduce the possibility of a fall or electric shock due to wet surfaces.

2.Wear ANSI-approved safety goggles during set up and use.

3.Only feed cold, clean water through this tool. Pressure washer detergent may be used in the soap dispenser only. Do not use caustic materials, solvents, flammable materials, or detergents not designed for pressure washers. Use of any such material can cause injury,

or damage this tool or personal property.

4.Prior to starting the Pressure Washer in cold weather, check all of the parts of the unit to make sure ice has not formed. Do not store the unit anywhere that the temperature will fall near 32° F (0° C).

Maintenance

SKU 69488

For technical questions, please call 1-800-444-3353.

Page 3

Image 3
Contents Electric pressure Washer Table of Contents Maintenance Safety WarningsSet up Precautions Safety Setup OperationOperating Precautions Servicing a Double-Insulated Appliance SafetySetup Operation Maintenance Vibration HazardSymbology TyfeSaEtupS AtierOp Nanc Maint Components Safety Setup Operation MaintenanceSpecifications Setup Before UseAssembly TyfeSa EtupSAtierOp Nanc Maint Features Safety SetupOperation Maintenance Operating Instructions Work Piece and Work Area Set UpTool Set Up General Operating Instructions Become Familiar With your Machine Operating TipsMaintenance and Servicing Cleaning, Maintenance, and LubricationProblem Possible Causes Likely Solutions TroubleshootingPump Assembly Parts List Parts Lists and Assembly DiagramsTyfe DiagramPump Assembly Pressure Washer Parts List and Assembly Diagram Please Read the Following Carefully Limited 90 Day Warranty