HP 10 manual Light sensor board

Light sensor board

Description	Spare part number
Light sensor board (includes double-sided adhesive and microphone)	739810-001

Before removing the light sensor board, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

4.Remove the back cover (see Back cover on page 19).

5.Disconnect the battery cable from the system board (see Power button board on page 20).

6.Remove the rear-facing webcamera (see Rear-facing webcamera on page 27).

Remove the light sensor board:

1.Release the ZIF connector (1) to which the rear-facing webcamera cable is attached, and then disconnect the rear-facing webcamera cable (2) from the light sensor board.

2.Remove the light sensor board.

Reverse this procedure to install the light sensor board.

26 Chapter 4 Removal and replacement procedures