Reverse this procedure to install the battery.
Wireless antennas
Description | Spare part number |
|
|
Antenna Kit (includes WLAN antenna cables and transceivers and WLAN antenna cables and |
|
transceivers) |
|
|
|
Before removing the wireless antenna cables and transceivers, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 19).
5.Disconnect the battery cable from the system board (see Power button board on page 20), and then remove the following components:
a.Volume button board (see Volume button board on page 22)
b.Audio board (see Audio board on page 29)
c.Battery (see Battery on page 32)
Remove the wireless antenna cables and transceivers:
1.Disconnect the wireless antenna cables (1) from the system board.
NOTE: The wireless antenna cable labeled “1” connects to the “Main” terminal labeled “1”. The wireless antenna cable labeled “2” connects to the “Aux” terminal labeled “2”.
2.Release the wireless antenna cables from the retention clip (2) built into the display assembly.
34 | Chapter 4 Removal and replacement procedures |