HP dc73 Blade Client manual Enww

Page 31

CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation.

12.To install a new expansion card, slide the card under the slot cover retention latch and press the card down into the socket on the system board.

Figure 2-17Installing an Expansion Card

NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot.

13.Rotate the slot cover retention latch back in place to secure the expansion card.

14.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.

15.Replace the access panel.

16.If the computer was on a stand, replace the stand.

17.Reconnect the power cord and turn on the computer.

18.Lock any security devices that were disengaged when the access panel was removed.

19.Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for instructions on using Computer Setup.

ENWW

Removing or Installing an Expansion Card 25

Image 31
Contents HP Compaq Business PC Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix C External Security Devices Standard Configuration Features Product Features1Front Panel Components Front Panel Components2Media Card Reader Components Media Card Reader Components3Rear Panel Components Rear Panel Components4Keyboard Components Keyboard5Windows Logo Key Functions Using the Windows Logo KeySerial Number Location Special Mouse FunctionsServiceability Features Hardware UpgradesUsing the Small Form Factor Computer in a Tower Orientation Enww Smart Cover FailSafe Key Unlocking the Smart Cover LockEnww 4Removing the Access Panel Removing the Computer Access Panel5Replacing the Access Panel Hardware Upgrades Replacing the Computer Access Panel6Removing the Front Bezel Removing the Front BezelRemoving Bezel Blanks 9Replacing the Front Bezel Replacing the Front BezelDIMMs Installing Additional MemoryDDR2-SDRAM DIMMs 1DIMM Socket Locations Populating Dimm SocketsInstalling DIMMs Enww 2Expansion Slot Locations Removing or Installing an Expansion Card14Removing an Expansion Slot Cover Enww Enww 3Drive Positions Drive Positions19Secondary Hard Drive 6-32 Guide Screws Location Installing and Removing DrivesEnww 4System Board Drive Connections System Board Drive ConnectionsRemoving an Optical Drive 24Rotating the Drive Cage Down 25Removing the Optical Drive Installing an Optical Drive into the 5.25-inch Drive Bay27Installing the Optical Drive Enww Removing an External 3.5-inch Drive Enww Installing a Drive into the 3.5-inch External Drive Bay Enww Enww Enww Enww Removing and Replacing a Removable 3.5-inch Sata Hard Drive 40Removing the Thermal Sensor Hardware UpgradesEnww Enww Enww Table A-1Specifications SpecificationsStandard PS 4A @ 100 VAC 2A @ 200 VAC Plus PS 5A @ 100VAC Battery Replacement Type Enww External Security Devices Installing a Security LockCable Lock Padlock HP Business PC Security Lock Enww Preventing Electrostatic Damage Electrostatic DischargeGrounding Methods Computer Operating Guidelines and Routine Care Shipping Preparation Optical Drive PrecautionsCleaning SafetyIndex Enww
Related manuals
Manual 79 pages 17.44 Kb