HP ThinState Deploy
To perform an HP ThinState deployment:
1.Set the boot order in the F10 System BIOS to USB boot.
2.Attach the USB flash drive to the thin client unit you wish to deploy the captured image to, and then power on the unit.
3.Follow the
After you remove the USB flash drive and cycle power to the system, the image will unbundle. This process can take between
You may use the captured image (flash.ibr) found in the USB flash drive in combination with Altiris Deployment Solution to remotely image multiple thin client units.
NOTE: You must use flash.ibr in conjunction with the HP ThinState Deploy utility (e.g., ibr.exe). Flash.ibr is not compatible with Altiris’ rdeploy.exe or rdeployt.exe utilities. Please consult the HP Compaq Thin Client Imaging Tool at http://h20000.www2.hp.com/bc/docs/support/SupportManual/ c00485307/c00485307.pdf.
For more information about Altiris, see http://www.altiris.com/.
ENWW | HP ThinState Capture 37 |