Soleus Air SG-WAC-18ESE Assembly & Installation THRU-THE-WALL, Prepare and Install the Cabinet

Page 12

ASSEMBLY & INSTALLATION - THRU-THE-WALL (CONT.)

Carefully measure and cut an opening with the following dimensions depending on your model (FIG. 1 & 2).

WIDTH “X” = inside model plus twice the thickness of the framing material used.

HEIGHT “Y” = inside model height plus twice the thickness of framing material used.

Model

SG-WAC-25ESE

SG-WAC-15ESE /

 

 

SG-WAC-18ESE

 

 

 

Inside Frame

18 7/8” (47.9 cm)

18” (45.7 cm)

Height

 

 

 

 

 

Inside Frame

26 3/4” (67.9 cm)

23 7/8” (60.6 cm)

Width

 

 

 

 

 

NOTE: If wall thickness is 8-12” or more, add aluminum flashing over the bottom of the frame opening to assure water is unable to enter the area between the inner and outer wall.

FIG. 2

Prepare and Install the Cabinet

1. Slide the chassis from the cabinet. Refer back to the REMOVE CHASSIS instructions and FIG. 1-6 in the

WINDOW MOUNTING SECTION.

2. Place the cabinet into the opening with the bottom rail resting firmly on the bottom board of the wood frame.

3. Position the cabinet so it is tilted properly for water re- moval as seen below.

4.Build a wooden frame with the INSIDE dimensions of your model listed above (Measure twice). The frame depth should be the same as the wall thickness. Fill in extra space from the opening to the studs with wood spacers as shown below.

5.Nail the spacers to the studs. They should be flush with the dry wall.

4. Secure the bottom rail to the wood frame with two large 1” (2.5 cm) long wood screws as shown below.

11

Image 12
Contents SG-WAC-15ESE SG-WAC-18ESE SG-WAC-25ESE Page Important Safety Instructions Lcdi Power Cord and Plug Electrical RequirementsRecommended Ground Method It is the customer’s responsibilityParts List Tools NeededSpecifications ModelEER/C.O.P CFMInstallation & Assembly Instructions Prior to Installing the Air ConditionerWindow Preparation Storm Window RequirementsInstallation & Assembly Instructions Window Mounting Remove ChassisAssembly & Installation Top Angle Rail and Side Bracket InstallationTOP View Placing the Cabinet Inside the WindowInstall Support Brackets Install the Window Lock and Sash SealMark Extend the Accordion PanelsTHRU-THE-WALL Installation Installing the Chassis into the CabinetSelect the Wall Location Prepare the WallAssembly & Installation THRU-THE-WALL Prepare and Install the CabinetWindow Mounting Section Masonry Construction Support Bracket Wooden StripUsing Your AIR Conditioner Electronic Control Panel & Remote ControlRemote Control Normal Operating Sounds Air Conditioner ControlsUsing Your AIR Conditioner Care and Cleaning Air Filter CleaningCabinet Cleaning Winter StorageTroubleshooting Problem Possible Causes SolutionsProblem Possible Causes Water is dripping outsideWater is dripping inside the room Water collects in the base panWarranty One Year Limited Warranty66129903756