HP AR 18 Router manual Connecting the Ground Wire, 2AR 18-2X installation in a rack

Page 27

Installation Manual

Chapter 2 Installing the Router

H3C AR 18-2X Series Routers

1) Fixing the rack-mounting ears

2) Fixing the slides

Figure 2-2AR 18-2X installation in a rack

2.3 Connecting the Ground Wire

Caution:

Properly connect the ground wire before connecting other cables and shorten it as much as possible to prevent the router and the connected device from getting damaged during periods of lightning activities.

The grounding screw of the chassis PGND is located on the rear panel. Connect this screw to the earth ground using a ground wire. The grounding resistance must not be greater than 5-ohm.

2-5

Image 27
Contents H3C AR 18-2X Series Routers Installation Manual Technical Support About This Manual Manual ContentOrganization Chapter ContentsConvention Description Boldface ConventionsConvention Description II. GUI conventionsTable of Contents Introduction Product OverviewHardware Features of the AR Hardware Features of the ARAppearance Sdram II. System specificationsIII. LEDs IV. Interface attributesAttribute Description 10/100BASE-T Attribute3Front view of the AR II. System specifications LAN1/LAN2/L 5Front view of the AR 18-22-8/18-22S-8 Hardware Features of the AR 18-22-8/18-22S-8AR 18-22S-8 LAN1/LAN 7Front view of the AR 18-23-1/18-23S-1 Hardware Features of the AR 18-23-1/18-23S-1AR 18-23S-1 ETH0 LINK/ACT Connecting the Router to a Console Terminal Safety Precautions Installing the RouterPlacing the Router on a Tabletop/Workbench Installing the RouterMounting the Router on a Vertical Surface Installing the Router in a Rack 2AR 18-2X installation in a rack Connecting the Ground WireConnecting the Power Cord AC-input power supplyII. Connecting the AC-input power cord Connecting the Router to a Console Terminal II. Connecting the console cableConsole cable Ethernet cable Connecting the Router to LANII. Connecting an Ethernet cable Verifying InstallationInstallation Manual Starting up the Router Starting up the Router Setting up a Configuration EnvironmentConnecting the router to a console terminal II. Setting terminal parametersInstallation Manual Installation Manual Installation Manual 5Setting the terminal type Powering on the RouterMaintaining the Router Boot Menu 8 MB Flash Is InstalledPlease input Boot Rom password = clear field Installation Manual Boot Menu 16 MB Flash Is Installed Installation Manual Boot file File name File type =MAIN B=BACKUP S=SECURE Set this file as Main Backup Exit Enter your choice1-3 Installation Manual Upgrading an application program Upgrading Programs through XModemDownloading ... Ccccc Installation Manual III. Upgrading the extended segment of the Boot ROM program II. Upgrading the Boot Rom programWriting to FLASH.Please wait...#### Upgrading Boot ROM Through Tftp Upgrading Boot ROM at CLIH3C tftp 1.1.1.1 get bootromfull II. Upgrading Boot ROM Through FTP Installation Manual Upgrading Application Programs with NET Installation Manual Host inet h Press Enter as prompted to have the router reboot Troubleshooting Solution Troubleshooting the Power SystemTroubleshooting the Configuration System SymptomsSymptoms Recovering/Replacing a Lost Boot Rom Password
Related manuals
Manual 3 pages 18.26 Kb