Installation Instructions (Continuous)
6.INSTALL THE CASE IN THE WINDOW (cont.)
D.Adjust the leveling bolts and nuts against the outside wall so that the case has a slight tilt to the outside. Tighten nuts with an adjustable wrench. Use a level; about a 1/2 bubble will be the correct case slant to the outside.
E.Use a wood block (not supplied) between the leveling bolts and the wall if the wall is weak or if the weight of the air conditioner falls between the studs in the wall.
F.Extend the left and right accordion panels to the vertical window sashes. Drill pilot holes and attach the top and bottom corners with 4 type D screws.
7.INSTALL SUPPORT BRACKETS AND THE FOAM TOP WINDOW GAS KET
A.Attach the support brackets with two type D screws, one on each side.
B.Cut the foam top window gasket to the window width.
C.Stuff the foam between the glass and the window to prevent air and insects from getting into the room.
10