Soleus Air KC-45H installation manual Install the AIR Conditioner in the Case

Page 13

Installation Instructions (Continuous)

8.INSTALL THE AIR CONDITIONER IN THE CASE

A.Slide the air conditioner into the case. Do not push on the controls or the finned coils. Make sure the air conditioner is firmly seated.

B.Reinstall the locking bracket and screw removed earlier.

C.Reconnect the ground wire to the air conditioner using the screw removed earlier.

IMPORTANT: The ground wire must be reinstalled to ensure a proper ground.

D.Remove the front grille from its box and remove the shipping tape.

E.Grasp the inlet grille at the bottom corners and pull it forward. Unhook it from its top hinges and set it aside.

F.Using the tab, pull up slightly on the filter to release it and pull it down and out.

8.INSTALL THE AIR CONDITIONER IN THE CASE (cont.)

G.Pull the coiled power cord from its shipped position in the air discharge area. Attach the front grille frame to the case by inserting the tabs on the grille frame into the slots on the front top of the case. Push the grille frame in. And install the 2 side screws at bottom left and right side of front panel.

H.Secure the front grille frame to the case with one type C screw.

I.Reinstall the filter.

J.Reinstall the inlet grille. J Connect power.

11

Image 13
Contents BTU Room Air Conditioner with Heat Pump Table of Contents Introduction Safety InformationLcdi or Afci Power Cords Receptacle WiringUnpacking ElectricalRequirementsNormalCareandMaintenance InstallationRoomHeatPumps Annual InspectionFront Grille and Cabinet Cleaning Optional Charcoal Air Filter InstallationAir Filter Cleaning Front Grille and Filter RemovalSwitchover Thermostat Control Initial Start-Up and Cooling Drain Cup Installation and UseGeneralOperatingInstructions Changing Airflow Direction BafflesBefor E YOU Begin Installation InstructionsElectrical Requirements Tools YOU will NeedInstallation Instruction Continuous Window Requirements Installation Instructions ContinuousStorm Window Requirements Remove the AIR Conditioner from the CasePrepare the Case Install the Case in the WindowInstall Support Brackets and the Foam TOP Window GAS KET Install the Case in the WindowInstall the AIR Conditioner in the Case Install the AIR Conditioner in the CaseOperating Controls Temperature ControlFan Control Vent ControlProblem Possible Cause Suggested Remedy BeforeCallingServiceAny Questions? When Service Is RequiredConsumer Information Line Thru-wall Installation Instructions Brick Veneer or Frame Wall Construction Model KC-45H SpecificationsWarranty