Soleus Air KC-45H installation manual Thru-wall Installation Instructions

Page 17

Thru-wall Installation Instructions

Kit RS100 for Soleus Air brand Compact Room Air Conditioner

Introduction

This instruction sheet provides guidelines for installing a compact air conditioner through an outside wall.

Installing an air conditioner through a wall requires extensive carpentry and/or masonry experience. Thru-wall installations performed by inexperienced or unqualified individuals can result in costly damage to home.

Air Conditioner Dimensions

The following figures show the outside dimensions of air conditioner with chassis installed, and dimensions of outer case with chassis removed.

General Instructions

All Soleus Air brand Compact Room Air Conditioners feature a slide-out chassis. Chassis and front cover must be removed from outer case for installation.

In order to reinstall the chassis and reattach the air conditioner front cover, the installed outer case must be square and level from side to side. Use wood shims between sides of case and finished opening– especially where case is secured to opening–to prevent warping or distorting. Check installed case for distortion using carpenter’s square.

A finished opening 26 1/8 - inches wide x 17-inches high is recommended. The lower left inside corner of opening must be within 5 feet of an appropriate electrical outlet (see Use and Care manual for electrical requirements.)

When wall thickness exceeds 9 -inches, opening must be modified to allow air to enter side louvers on case (see special instructions on back ). Do not install air conditioner in walls thicker than 11 2/5 - inches.

Air Conditioner Dimensions

(with chassis installed)

Outer Case Dimensions

(chassis removed)

Dimensions of Finished Opening

Masonry Construction

See CAUTION under General Instructions. In masonry walls, cut or build a finished opening 17- inches high by 261/8-inches wide. When case is properly positioned in opening, secure it in place with mortar or concrete nails driven through holes in sides of outer case (shim case and predrill holes before securing with nails).

15

Image 17
Contents BTU Room Air Conditioner with Heat Pump Table of Contents Introduction Safety InformationLcdi or Afci Power Cords Receptacle WiringUnpacking ElectricalRequirementsNormalCareandMaintenance InstallationRoomHeatPumps Annual InspectionFront Grille and Cabinet Cleaning Optional Charcoal Air Filter InstallationAir Filter Cleaning Front Grille and Filter RemovalSwitchover Thermostat Control Initial Start-Up and Cooling Drain Cup Installation and UseGeneralOperatingInstructions Changing Airflow Direction BafflesBefor E YOU Begin Installation InstructionsElectrical Requirements Tools YOU will NeedInstallation Instruction Continuous Window Requirements Installation Instructions ContinuousStorm Window Requirements Remove the AIR Conditioner from the CasePrepare the Case Install the Case in the WindowInstall Support Brackets and the Foam TOP Window GAS KET Install the Case in the WindowInstall the AIR Conditioner in the Case Install the AIR Conditioner in the CaseOperating Controls Temperature ControlFan Control Vent ControlProblem Possible Cause Suggested Remedy BeforeCallingServiceConsumer Information Line When Service Is RequiredAny Questions? Thru-wall Installation Instructions Brick Veneer or Frame Wall Construction Model KC-45H SpecificationsWarranty