| HDV Series Direct Vent Gas Fireplace |
Before You Start
Read this homeowner manual thoroughly and follow all instructions carefully. Inspect all contents for shipping damage and immediately inform your dealer if any damage is found. Do not install any unit with damaged, incomplete, or substitute parts. Check your packing list to verify that all listed parts have been received. You should have the following:
•Fireplace (Firebox and Burner System)
• | Log Set | • | Front Floor Brick (2 pcs) |
• | White Toggle Switch | • | Rock Wool |
•
• Switch Cover Plate | • Canopy |
•Restrictor Plate/Disc (2)
Items Required For Installation
• | Phillips Screwdriver | • | Framing Materials |
• | Hammer | • | Wall Finishing Materials |
• Saw and/or saber saw | • | Level | |
• | Measuring Tape | • Electric Drill and Bits | |
• | Tee Joint | • | Pliers |
• | Square | • | Pipe Wrench |
•Fireplace Surround Material (Noncombustible)
•Piping Complying with Local Codes
•Pipe Sealant Approved for use with Propane/LPG (Resistant to Sulfur Compounds)
fireplace framing
Firebox framing can be built before or after the appliance is set in place. Refer to Figure 2 for firebox and framing dimensions. The framing headers may rest on the top of the firebox standoffs.
The firebox may be installed directly on a combustible floor or raised on a platform of an appropriate height. When the firebox is installed directly on carpeting, tile, or other combustible material, other than wood flooring, the firebox shall be installed on a metal or wood panel extending the full width and depth of the enclosure.
NOTE
COLD CLIMATE INSULATION
If you live in a cold climate, seal all cracks around your appliance, and wherever cold air could enter the room, with noncombustible material. It is especially important to insulate the outside chase cavity between the studs and under the floor on which the appliance rests, if the floor is above ground level.
56D3048
