Monessen Hearth HDV500NV/PV manual Signature Command System Operation Instructions Features

SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS

FEATURES

Command Center

•Easy Access Function Operation and System Configuration

•Operation Confirmation/Fault Diagnostic Indications (LED/ Buzzer)

•ON/OFF/HI/Low Operation

Control Board

•Electronic Ignition

•Pilot Lockout safety feature

•Electric Power Regeneration from Thermopile to save bat- tery

•6-hour Automatic Shut Down Option

•Convenient NG/LP Gas Type Conversion

•Standing Pilot/Intermittent pilot Conversion

•Previous settings Restoration Ability

•Uninterrupted Operation During Power Outage (Automatic Battery Backup)

•ON/OFF RF Remote Receiver

•Optional Transmitter Learn Capability

AC Interface Board (Optional)

•Easy Snap-on Design

•Embedded Compact 120 VAC Adapter with Auto Battery Back up Feature

RF Receiver	To Thermopile
ON/OFF	To Sensor
	To Sparker

NG/LP

Conversion

	To Command Center
Control
Board	To Stepper Motor
	To Valve
	Battery Door

Command

Center

Master Switch

ON

LED

OFF

Figure 54 -

Signature Command System Components

•Remote Controlled Blower, Lighting, and Auxiliary AC Out- puts

Transmitter (Optional)

	RFSC	RTSC	RMSC
Three Flame Height Settings	X	X	X
Low battery Indication for Transmitter	X	X	X
Child Proof Lock-out	X	X	X
LCD Backlight	X	X	X
Security Codes	X	X	X
Thermostatic Control Mode	X	X	--
Three Brightness Settings for Lights	X	--	--
Three Speed Control for Blower	X	--	--
On/Off Auxiliary	X	--	--
Programmable Timer to turn blower on and off	X	--	--

BATTERY INSTALLATION

The Command Center uses four (4) "AA" batteries.

To Install Batteries:

1.Press down the battery door tabs and pull out to remove battery door.

2.Install the batteries as indicated on Command Center.

3.Close battery door by snapping in place.

4.When the four (4) batteries are installed the system is ready for use.

5.The batteries should be replaced when the LED indicates low battery.

56D3048 39