Soleus Air SG-WAC-18HCE manual Using Your AIR Conditioner

Page 15

USING YOUR AIR CONDITIONER (Cont.)

•Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.

•Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air condi- tioner.

•The remote control has a signal range up to 20 feet.

•Make sure nothing is blocking the remote con- trol signal from being received by the air con- ditioner.

•Make sure the batteries are installed correctly and still have power.

•Cooling Mode: Use the COOL mode at Low, Me- dium, High, or Auto Fan speed when cooling is needed. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F.

•Once the temperature is set, the compressor will cycle on and off to keep the room temperature at the set temperature level. The lower the set thermostat temperature, the cooler the room will become. The higher the set thermostat temperature, the warmer the room will become.

•For Normal Cooling - Set the Mode to Cool and the Fan to High or Med with the termperature set in the middle.

•For Maximum Cooling - Set the Mode to Cool and the Fan to High with a lower set temperature.

•For Quieter & Nighttime Cooling - Set the Mode to Cool and the Fan to Low with the temperature set in the middle.

NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.

•Heat Mode: Use the Heat mode at Low, Med, High or Auto Fan Speed for heating. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F in 1°F increments.

•For Normal Heating - Set the Mode to Heat and the Fan to High or Med with the termperature set in the middle.

•For Maximum Heating - Set the Mode to Heat and the Fan to High with a lower set temperature.

•For Quieter & Nighttime Heating - Set the Mode to Heat and the Fan to Low with the temperature set in the middle.

•Energy Saver Mode - Controls the Fan

On - The fan will cycle on and off with the compressor. This results in winder variations of room temperature and humidity. Normally used with the room is unoccupied. NOTE: The fan my continue to run for a short time after the compres- sor cycles off.

Off - The fan runs all the time in fan or cooling mode.

•Fan Only Mode: Use Fan Only mode at Low, Med, or High fan speed to provide air circulation and filtering without cooling. Since fan only setting do not provide cooling, a Set temperature cannot be entered. The room temperature will appear in the display.

NOTE: Auto Fan Speed cannot be used in Fan Only mode.

•Loss of Power Protection: If power to the air conditioner is lost or interrupted, the air condi- tioner will automatically re-start in the setting last used prior to power loss. If the Timer was set to automatically turn the air conditioner off or on, it will resume countdown at the amount time left prior to power loss. You may need to set a new time if desired.

•Air Direction: Use the lever near on the front air vents to adjust the direction of the airflow. You can direct the airflow left or right only. The lever is located on the right side of the air vent.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents SG-WAC-18HCE Important Safety Instructions Lcdi Power Cord and Plug Electrical RequirementsRecommended Ground Method Non-Hardware Packing List Parts List Tools NeededSpecifications DisclaimerModel Storm Window Requirements Installation & Assembly InstructionsPrior to Installing the Air Conditioner Window PreparationPage Remove Chassis Installation & Assembly Instructions Window MountingPlacing the Cabinet Inside the Window Assembly & InstallationTop Angle Rail and Side Bracket Installation TOP ViewMark Install Support BracketsInstall the Window Lock and Sash Seal Extend the Accordion PanelsPrepare the Wall THRU-THE-WALL InstallationInstalling the Chassis into the Cabinet Select the Wall LocationPrepare and Install the Cabinet Assembly & Installation THRU-THE-WALLSupport Bracket Wooden Strip Masonry ConstructionNormal Operating Sounds Using Your AIR ConditionerElectronic Control Panel & Remote Control Remote ControlUsing Your AIR Conditioner Using Your AIR Conditioner Winter Storage Care and CleaningAir Filter Cleaning Cabinet CleaningProblem Possible Causes Solutions TroubleshootingWater is dripping outside Water is dripping inside the roomWater collects in the base pan One Year Limited Warranty Warranty

SG-WAC-18HCE specifications

The Soleus Air SG-WAC-18HCE is a versatile and efficient window air conditioning unit designed to provide optimal cooling solutions for medium to large-sized rooms. With a cooling capacity of 18,000 BTUs, this model effectively combats the heat and humidity, ensuring a comfortable indoor environment. The unit is engineered with advanced technologies and features that enhance usability, energy efficiency, and overall performance.

One of the standout features of the SG-WAC-18HCE is its Energy Efficiency Ratio (EER) rating, which helps users save on electricity bills while still enjoying effective cooling. The appliance is equipped with a programmable timer, enabling users to set specific operating hours and temperature preferences. This results in further energy savings, as the unit can be programmed to cool only when needed.

The air conditioner also includes a variety of airflow settings, making it adaptable to individual preferences. Its three cooling speeds and two fan speeds allow for customizable comfort levels, while the 4-way adjustable air direction ensures that air circulation is optimized throughout the room. Furthermore, the unit operates quietly, thanks to its innovative design, making it suitable for bedrooms and workspaces where noise reduction is a priority.

Installation is simplified with the included user-friendly instructions, and the removable, washable filter allows for easy maintenance and improved air quality. The SG-WAC-18HCE is also equipped with a dehumidification function, which extracts excess moisture from the air, creating a more comfortable living space during humid weather conditions.

Safety features have not been overlooked in this model. It comes with a built-in safety switch that automatically shuts off the unit if it overheats, providing peace of mind for users. Additionally, the unit includes a “Follow Me” feature that utilizes the remote control’s built-in thermostat to sense the temperature of the room, allowing for more precise temperature control.

Overall, the Soleus Air SG-WAC-18HCE is an excellent choice for anyone looking for a reliable and efficient window air conditioner. With its robust cooling capacity, energy-saving features, quiet operation, and user-friendly design, it stands out as an effective solution for ensuring a cool and comfortable home environment during the hot summer months.
Top Page Image Contents