Paper Out Override, Default = No
Senses when less than 1" (25 mm) of paper remains and stops printing. Change to Yes to override the sensor and print closer to the bottom of the page.
CAUTION!
Engaging Paper Out Override can cause loss of data and damage the printhead by allowing printing without paper.
Parity, Default = None
Appears only when the optional Serial Interface is installed. Selects the type of parity your system uses: None, Odd or Even.
Pin 18, Default = +5V
Sets the signal on pin 18 to +5 volts or open.
Pitch, Default = 10 cpi
Choose the character width in characters per inch (cpi).
Power Save Time, Default = 5 min.
Sets the interval the printer waits for more data before it goes into the power save mode. Power Saving must be set to Enable (the factory default) for this to be effective.
Power Saving, Default = Enable
Change to Disable if you wish to prevent the printer from entering the Power Save mode after the selected interval.
Print Mode, Default = LQ Courier
Choose the quality and typeface of printing.
Print Registration, Default = 0
Change the setting as required to obtain the best registration for bi- directional printing.
MENU MODE > 40