4.Use the arrow buttons to set the number of copies (between 1 and 99) that you want as the default.
5.Press OK to save your selection.
Cancel a copy job
To cancel a copy job, press Cancel on the product control panel. If more than one process is running, pressing Cancel clears the process that currently appears on the product
NOTE: If you cancel a copy job, clear the document from the flatbed scanner.
Reduce or enlarge copies
Reduce or enlarge copies for the current job
1.On the product control panel, press More Copy Settings.
2.Use the arrow buttons to select Reduce/Enlarge, and then press OK.
3.Select the size to which you would like to reduce or enlarge the copies in this job.
NOTE: If you select Custom:
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or landscape).
4.Press Start Copy to save the selection and immediately start the copy job, or press OK to save the selection without starting the job.
NOTE: The change in the setting remains active for about 2 minutes after the copy job has been completed. During this time, Custom settings appears on the product
You must change the default media size in the media input tray to match the output size, or part of your copy might be cut off.
Adjust the default copy size
NOTE: The default copy size is the size to which copies are normally reduced or enlarged. If you keep the factory default size setting of Original=100%, all copies will be the same size as the original document.
1.Press Setup.
2.Use the arrow buttons to select Copy setup, and then press OK.
3.Use the arrow buttons to select Def. Redu/Enlrg, and then press OK.
4.Use the arrow buttons to select the option for how you normally want to reduce or enlarge copies.
NOTE: If you select Custom:
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or landscape).
5.Press OK to save the selection.
The product can reduce copies to as little as 25% of the original size or enlarge copies to as much as 400% of the original size.
ENWW | Use copy 53 |