HP 615N manual Parameter Expected Messages for 10/100TX Cards, Port Select

Note	The HP Jetdirect 10/100Base-TX print server may
	require up to 10 seconds to establish a connection
	on the network.

Try the following troubleshooting procedures:

●Verify cabling connections.

●Configure the print server’s 10/100TX link setting directly (for example, using the EIO menu on the printer’s control panel). Verify that the configuration of the connecting network device (such as a network switch) matches. For example, if you set the print server for 100Base-TX Full-Duplex operation, the port on the network switch must also be set to 100Base-TX Full-Duplex operation. Power-cycle the printer to reinitialize the setting.

●On the Jetdirect Configuration Page, compare your configuration for the following parameters:

Parameter	Expected Messages for 10/100TX Cards
PORT SELECT:	RJ-45
PORT CONFIG:	100TX HALF, 100TX FULL, 10BASE-T HALF,
	10BASE-T FULL
AUTONEGOTIATION:	ON (Autonegotiation is enabled), or
	OFF (Autonegotiation is disabled, 10/100TX
	configuration has been manually set)

For other configuration parameters and messages on the Jetdirect Configuration Page, refer to the applicable HP Jetdirect Administrator’s Guide provided on the HP Jetdirect CD-ROM.

ENWW Troubleshooting Tools 24