HP 615N manual Remove Power to Printer, Install the Hardware, RJ-45

Page 11

Remove Power to Printer, Install the Hardware

Figure 2-1 Remove Power, Install and Connect the Card

RJ-45

1.Turn off the printer and remove the printer’s power cord.

2.Identify an available HP Enhanced I/O (EIO) slot (typically, in the back of the printer).

Note	For printers with multiple EIO slots, you can install
	the print server into any EIO slot in the HP printer.

3.If the slot has a cover plate, remove it.

4.Insert the print server card. Align the card with the guide rails in the slot.

5.Press the card into the slot until firmly seated and tighten each retaining screw a little at a time until both screws are secure.

6.Connect the network cable to the card using the RJ-45 connector port.

7.Turn on the printer.

ENWW	Installation Procedures 11

Image 11

Contents Hp jetdirect Setup Guide HP Jetdirect Print Servers Models 620n/615n EIO Applicable Products Table of Contents HP Jetdirect EIO Control Panel Menus HP Jetdirect Solutions SummarySpecifications and Regulatory Statements Warranty Service HP Support and ServiceHP Jetdirect EIO Print Server IntroductionTypical HP Jetdirect Print Server Installation What You Need For Help Installation Procedures Verify Printer Operation RJ-45 Remove Power to Printer, Install the HardwareVerify Jetdirect Print Server Operation Applicable HP Jetdirect Administrator’s GuideSee in this guide for link configuration Configuration Tools If Required, Configure Jetdirect With Your Network SettingsMenus Add the Printer to Your Network Server or System Adding a Printer to Your System ConfigurationMicrosoft or Novell NetWare Networks Client-Server Networks Apple Mac OS Networks Unix NetworksTo View Documents on the CD-ROM For other supported operating systems, you can 10/100Base-TX Link Configuration Troubleshooting Tools HP Jetdirect ConfigurationLED State Description Link TroubleshootingLink-Speed LEDs Parameter Expected Messages for 10/100TX Cards On Autonegotiation is enabled, orOFF Autonegotiation is disabled, 10/100TX Configuration has been manually setControlling Network Protocols Resetting to Factory DefaultsEnabling or Disabling Network Protocols Client-Server printing Peer-to-Peer printingNetwork Addresses Network ProtocolsTable A-1 Using HP Jetdirect CD-ROM Software Network System Setting Up Your Network PrinterHP-UX IPXUnix networks HP Jetdirect Printing Support HP Jetdirect Solutions Summary Tools OverviewDLC/LLC Supported Network ProtocolsTCP/IP IPX/SPXHP Jetdirect Printer Installer for Unix HP Installation SoftwareHP Internet Printer Connection HP LaserJet Utility for Mac OS Table B-3. HP Software Solutions 3 HP IP/IPX Printer GatewayHP Jetdirect EIO Control Panel Menus Introduction Classic Control Panel CFG TCP/IP= Https CFG IPX/SPX=CFG LINK= WEB=Host Name TCP/IP EnableGraphical Control Panel Dhcp Renew ConfigMethod Dhcp ReleaseManual SettingsDefault IP IPX/SPX EnableFrame Type Atalk EnableDLC/LLC Enable ResetSpeed LinkEnvironmental Specifications and Regulatory StatementsHP Jetdirect EIO Internal Print Server ElectricalJ7934A 620n J6057A 615n Regulatory StatementsElectromagnetic FCC StatementsEuropean Community Declaration of Conformity HP Jetdirect Print ServersRRL Statement Korea AustraliaCanada Vcci JapanTaiwan Class a Chinese Safety StatementHP Product Duration of Limited Warranty Warranty ServiceYour Authorized Dealer Firmware Upgrades HP Support and Service HP Support OnlineTable F-1 Support Telephone Numbers 1 HP Support By PhoneUSA Table F-1 Support Telephone Numbers 2Denmark + 45 39 29 Portugal +351 21 Finland SARHewlett-Packard Development Company, L.P