HP FB950 manual Details on Specific Media Types, Acrylic Sheet Plexiglas and other brand names

Page 8

Details on Specific Media Types

Acrylic Sheet (Plexiglas® and other brand names)

Considerations

Supported (

) print modes and resolutions:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1200x600

600x600

 

600x300

 

 

 

 

 

 

 

 

 

 

 

 

 

HQ

Prod

BB

HQ

Prod

BB

HQ

Prod

 

BB

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Recommendations for best results

Preparation

Peel the protective film off one side. If firmly affixed to media, adhesive-backed protective films can be left on the backside while printing. This type of film creates less static when removed but without it material can slip causing problems with registration. Print on the side without any lettering or graphics on the protective film to avoid transfer effect from printed areas.

Wipe the media with an anti-static cloth or other device to remove static charge and possible cutting remnants. Use only alcohol or approved plastic cleaner if needed.

Printing

These materials are heavy in larger sizes. Do not exceed the maximum weight stated in the specifications. Flatness, size, smoothness, and weight will affect the consistency of media feed through the printer.

Depending on end-use application, ink adhesion may be an issue. Clean the media as directed and use a color profile that has low ink saturation.

Ink saturation and curing is best with Production or High Quality Modes in 600x600. If the application calls for reverse printing the image will need to be flipped in the server or at the application.

Use Low or Medium lamp settings depending on the material’s tolerance to heat.

These materials are usually heavy enough to lie flat, but it is important that there is a sufficient level of vacuum to facilitate registration a setting of 5 should provide reasonable balance.

Media may expand and contract during printing so a slightly higher head height than nominal (0.085 inches or 0.216 cm.) may be needed to prevent the carriage from rubbing.

Use Backlit or UV White Opaque Film color profiles, or generic dot gain model depending on application.

Media Feed Calibration is not necessary when switching between media types or when switching between sizes.

Output Handling

Take care when lifting sheets off the table as media, especially polycarbonate, may scratch. Use clean, cotton gloves to avoid fingerprints.

8

Image 8
Contents Media Usage on the Scitex FB950 Printer Page Table of Contents Page Media Compatibility Print Mode ConsiderationsIntroduction Flexible Media Media Type Supported Print Details ModesRigid Media Tests show reliable results with the following rigid mediaDetails on Specific Media Types Acrylic Sheet Plexiglas and other brand names∙ No special handling required Card Stock ∙ C-size flutes or smaller sizes perform bestClear Vinyl Sheet Corrugated Fiberboard Fluted Polypropylene Coroplast and other brand names Foam Board Fome-Corand other brand names Foamed PVC Sintra and other brand names Glass Petg Clear Plywood and Medium Density Overlay MDO Plywood Materials Polycarbonate Sheet Lexan, Makrolon, Tuffak Polystyrene Sheet Considerations Media Feed Table SetupGeneral Recommendations Other Printer Configuration Notes Media PropertiesPrint Mode Selection Static ElectricityUsing the Straight-Through Media Path Loading MediaLoading Media for Edge-to-Edge Printing Edge-to-Edge PrintingMedia Measurement Options Overprinting Two-Sided Printing General NotesLoading Media for Two-Sided Printing Preparing Image for Two-Sided PrintingUneven Rows Multiple Sheet PrintingMargins 2010-09