Panasonic DMR-E100H warranty Error messages, On the television, On the unit’s display

Error messages

On the television		Page
Error has occurred. Please	≥A serious, but temporary error has occurred and one of the unit’s safety devices has activated.	—
press ENTER.	Press [ENTER]. The unit switches to the standby mode. Press [Í, DVD POWER] to turn the
	unit on again.
No disc.	≥The disc is upside down.	14
No valid disc.
No PC card.	≥The card is not inserted. If this message is displayed with a compatible card already inserted,	22
No valid PC card.	turn off the power, remove and then re-insert the card.
No SD card.	≥The card inserted is not compatible or the card format does not match.	11
No valid SD card.	≥Format the card.	40, 42
This is non-recordable disc.	≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R.	10
	≥You cannot format a microdrive or mobile hard disk on this unit.	—
This disc is not formatted
properly.
Unable to format.
No disc can be read.	≥You inserted an incompatible disc.	10
This disc cannot be read.	≥An unformatted DVD-RAM is in the tray. Format the DVD-RAM.	44
No valid HDD card.	≥Insert a mobile hard disk that has been recorded using a Panasonic SD media storage device.	—
Please check write protect tab	≥Release protection from the DVD-RAM cartridge or the card.	—
on the disc cartridge.	LOCK
Cannot write.	PROTECT
Protected programs are	≥The program is write-protected. Cancel the protection.	36
existed.
Contents of this disc are pro-	≥The disc is write-protected. Cancel Disc Protection.	44
tected.
Cannot finish recording com-	≥The program was copy-guarded.	—
pletely.
Cannot record. Disc is full.	≥No space left on the HDD, disc or card.	36
	‹ Create space by erasing any unwanted programs. [HDD] [RAM]
Cannot record. Maximum
	‹ Use a new disc or card.	—
amount of programs exceeded.
Cannot record on the disc.	≥The disc is scratched. Use another disc.	—
	≥The disc is dirty.	62
Please change the disc.	≥Press [<] to remove the disc. (Power goes off.)	—
This disc may not be played in	≥You tried to play a disc with a region number different from this unit’s region number. This unit	Cover
your region.	can only play discs with the region numbers compatible with this unit (1, All, or including the	page
	number 1).
Your selection exceeds the	≥A ratings level has been set for DVD-Video with this unit. Unlock the unit with “Ratings” in	51
recorder’s rating limit.	“Disc”.
Finalizing is necessary for	≥To enable playback of your DVD-R on compatible equipment, it is necessary to finalize it.	44
compatible playback.
/	≥Operation is restricted on this unit or disc.	—
Cannot playback on this unit.	≥You tried to play a non-compatible image.	11
	≥Turn the power off on the main unit and re-insert the card.	22
No folder	≥There is no compatible folder in this unit.	23
On the unit’s display
NO READ	≥The disc is dirty or badly scratched.	62
	‹ Clean the disc if it is dirty.
	‹ The disc cannot be played if it is scratched and this display doesn’t disappear.	—
	≥The unit cannot read the disc.	—
	≥You have used a DVD-RAM/PD lens cleaner and it has finished.	—
SELF CHECK	≥There was a power failure or the AC plug was disconnected while the power was on. The unit is	—
	carrying out its recovery process. Wait until the message disappears.
UNSUPPORT	≥You have inserted a disc the unit cannot play or record on.	10
HARD ERR	≥If the message does not go away after turning the power off and on, consult your dealer for ser-	—
	vice.
HDD SLEEP	≥In order to extend HDD life, the HDD is in SLEEP mode.	11
PROG FULL	≥There are already 32 timer recordings. Erase unnecessary timer recordings.	29
∑ CHK REMOTE	≥The remote control and main unit are using different codes. Change the code on the remote	54
(“∑” stands for a number.)	control.
U14	≥The unit is hot.	—
	‹ The unit switches to standby automatically for safety reasons and you cannot operate it.
	Wait for about 30 minutes for the service number to disappear.	—
	‹ Select a position with good ventilation when installing the unit.
	‹ Do not block the cooling fan on the rear of the unit.	—
U99	≥The unit fails to operate properly. Press [Í, DVD POWER] to switch the unit to standby. Now	—
	press [Í, DVD POWER] again to turn the unit on.

Reference

63

RQT6986