HP manual HP DesignJet 430, 450C and 455CA Printers

Page 14

4Load the film￿ with the matte ￿dull￿ side down￿ in portrait orientation into the Printer￿

5When the Ready LED lights up￿ press Reprint key.

The Ready LED begins to flash and the Printer takes several minutes to plot the calibration plot. The Printer ejects the sheet, and the Load Media LED lights up.

6Unload the sheet￿

7Wait until the ink on the sheet is dry￿

8Cut the sheet along the dotted line and reload the sheet facedown into the Printer￿ in the direction indicated by the arrows on the calibration plot￿

The Ready LED begins to flash. The Printer takes less than 10 minutes to: read the calibration sheet; calculate the calibration data; save the data in the EEROM; and eject the sheet.

9Unload the sheet￿

12 Quick Reference Service Manual

HP DesignJet 430, 450C and 455CA Printers

Image 14
Contents HP DesignJet 450C HP DesignJet 455CA PrintersENGLISH WarrantyWARNING +#&&* % What can I do if the Media continuously crashes? What can I do if the Printer does not Power ON?What can I do if the Printer has problems with the Cutter? What can I do if the Bail Mechanism Fails? System rror CodesWhat can I do if the Cover Sensor isnt Working? HP DesignJet 430, 450C and 455CA Printers HP DesignJet 430, 450C and 455CA Printers Stopping a Test Service TestsEntering Service Mode Front anel TestLine Sensor Test Failure Carriage TestCartridge Continuity Test Failure Analog Multiplexer Test FailureModular Test Media3Axis X3Axis TestBench Run Bail Test Service Monitor Data DisplayElectronics Test Electrical TestEerom Model ID Configuration Procedure Calibrations HP DesignJet 430, 450C and 455CA Printers
Related manuals
Manual 125 pages 4.1 Kb