HP 240A, 340A manual Degree Degrees Output Minimum value Maximum value

When [Document Size] Is Set to [Auto] and [Zoom Mode] Is Set to [Coordinate Area]

The [Hard Clip] setting becomes ineffective. The extended hard clip area is always used. The scaling factor is determined by the effective coordinate area and output size.

The following table summarizes effective coordinate areas by paper size.

Note
•	Some output sizes may not be used depending on the printer type.						Unit: Plotter unit
		0 degree				90 degrees
Output
	Minimum value		Maximum value		Minimum value		Maximum value
size
	P2x-P1x	P2y-P1y	P2x-P1x	P2y-P1y	P2x-P1x	P2y-P1y	P2x-P1x	P2y-P1y
A3	7829	5485	73075	51200	5485	7829	51200	73075
A4	5485	3828	51200	35733	3828	5485	35733	51200
A5	3828	2648	35733	24720	2648	3828	44088	35733
B4	6762	4723	63120	44088	4723	6762	44088	63120
B5	4723	3297	44088	30773	3297	4723	30773	44088

The maximum scaling factor is equivalent to 210% of the size of the extended hard clip area of each paper and the minimum scaling factor is equivalent to 22.5%.

Limits During Auto Layout Mapping

When the Hard Disk (Optional) Is Installed in the Printer

Print data is stored to the hard disk when Auto Layout is executed.

When the Hard Disk (Optional) Is Not Installed in the Printer

Print data is stored to the Auto Layout memory when Auto Layout is executed. The initial capacity of the Auto Layout memory is 64 KB. Therefore, this printer cannot correctly output auto layout if the print data received by the auto layout memory exceeds 64 KB. In this case, change the size of the Auto Layout memory from the printer control panel. The upper limit of the Auto Layout memory is 5,120 KB. The auto layout memory cannot accept data larger than 5,120 KB.

We recommend installing the hard disk to this printer if you are going to use the auto layout function.

343 Materials Related to HP-GL Mode