HP 340A, 240A manual Determining the Scaling Factor, Output size Document

Determining the Scaling Factor

During execution of auto scaling, the scaling factor is determined by the document size and output size. Note that the scaling factor depends on the [Zoom Mode] setting.

Note

•To enable the scaling function, set [Zoom] to [On] on the control panel. If [Zoom] is set at [Off], images will be drawn at a scale of 100%.

When [Document Size] Is Set to [Auto] and [Zoom Mode] Is Set to [Output Size]

The [Hard Clip] setting becomes ineffective. The output size hard clip area is always used.

•When the document size is the same as the output size, the image is drawn at a scale of 100%.

•When the document size is larger than the output size, the image is drawn with it reduced.

•When the document size is smaller than the output size, the image is drawn at a scale of 100%.

Output size	A3	A4	A5	B4	B5
Document
A0	35	25	100	31	100
A1	50	35	25	43	31
A2	71	50	35	61	43
A3	100	71	50	87	61
A4	100	100	71	100	87
A5	100	141	100	173	100

Note

•When origin position is set to layout, the image is drawn with the document laid out at the center. When origin position is set to bottom left or center, the image is drawn with the origins of the document and paper aligned.

•Some output sizes may not be used depending on the printer type.

3.3 Auto Layout 33