HP UPS R1500 GENERATION 2 manual Battery runtime, Environmental specifications

Page 38

Feature	Specification

Charging	Advanced charging for faster recovery. Complete charge takes
	no more than 24 hours. After approximately 4 hours, the
	batteries reach 90% charge at default nominal utility voltage and
	no load.

Battery runtime

Load, percent	Load, watts	Estimated battery runtime at 100% battery charge

20	200	58 minutes

50	500	17 minutes

80	800	8 minutes

100	1000	5 minutes

Environmental specifications

Feature	Specification

Operating temperature	0°C to 35°C (32°F to 95°F)

Nonoperating	-15°C to 55°C (5°F to 131°F)
temperature

Relative humidity	5% to 95%; noncondensing

Operating altitude	Up to 3,000 m (9,843 ft) above sea level

Nonoperating altitude	Up to 15,000 m (49,212 ft) above sea level

Audible noise	Less than 45 dBA

Serial communications port pin assignment

Specifications 38

Image 38

Contents HP UPS R1500 Generation 2 User Guide Part Number December 2009 Second EditionIntended audience Contents Ordering spares UPS spare parts list Hardware options Before you contact HP HP contact informationElectrostatic discharge UPS front panel Component identificationUPS R1500 G2 overview UPS front panel controls Description FunctionUPS front panel LED indicators UPS R1500 G2 NA/JPN/TWN rear panelUPS R1500 G2 Intl rear panel DescriptionInput power connector IEC-320-C14 power inlet Preparing to install the hardware InstallationPrecautions Tools requiredInstalling the mounting rails Readying the equipmentInstallation Installation Installation Installing the UPS Tighten the wing nuts or hex nutsConnecting the batteries Connect the battery lead to the battery terminal Attaching the UPS front bezelSelecting the UPS voltage configuration Connecting the host computerConnecting the USB communications port Connecting the Network Transient ProtectorsConnecting the serial communications port Connecting the UPS to utility power Connecting devices to the UPSPowering up the UPS Charging the UPS batteriesUPS operations Standby modeOperate mode Modes of operationBattery mode Silencing an audible alarmPowering down the UPS Initiating a self-testPower management Power management softwareMaintenance Removing the UPS front bezel Replacing the UPS option cardTo replace the component, reverse the removal procedure Important battery safety informationBattery care and storage guidelines Replacing the batteriesUPS battery replacement procedure Replacing the UPS Testing the new battery moduleTo remove the UPS Power down all attached load devices Configuring a USB to serial converter Updating the UPS firmwareReassigning the USB COM ports Cleaning battery spills Red Silenced Yellow TroubleshootingLED and audible alarm troubleshooting UPS does not provide the expected backup time UPS operates on battery onlyUPS frequently switches between utility and battery power UPS does not startUPS emits a slight clicking noise Site wiring conditionUPS cannot communicate with the host computer UPS input specifications SpecificationsUPS physical specifications UPS output specificationsVoltage specifications Battery specificationsPower protection specifications Output tolerance specificationsSerial communications port pin assignment Battery runtimeEnvironmental specifications Pin Signal Function Direction from the UPS Number Name DSROrdering spares UPS spare parts listSpares Hardware optionsHP contact information Technical supportBefore you contact HP $250,000 Computer Load Protection Guarantee Warranty informationLimited warranty Pre-Failure Battery WarrantyRecommended duration of use Federal Communications Commission notice Regulatory compliance noticesRegulatory compliance identification numbers Modifications CablesCanadian notice Avis Canadien European Union regulatory noticeJapanese notice Class a equipment Class B equipment Battery replacement noticeBsmi notice Korean notice Power cord statement for Japan Grounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge Acronyms and abbreviations Index LEDs, troubleshooting USB connectors