HP manual Connecting the Slave Renderer to a Lustre Workstation, HP Z800 Workstation

HP Z800 Workstation

To USB extender

Network Switch

Ports 3 and 4 to	NETGEAR
additional panels	PWR	1	2	3	4	5	6	7	8

To port 1 on USB Extender

Autodesk Control Surface

		y	Autodesk
System Power	Link	Activit
5V DC 4A	Ethernet		Tablet
+	-

NOTE The illustration shows the central panel only (the Colour Grading panel). This panel is easily identified, since it has both an Ethernet network port and a USB connector. It is also the panel with the built-in tablet.

To connect the Autodesk Control Surface:

1Connect each panel to a power supply using the AC power adapter cables.

2Use network cables to connect each panel to the available ports in the network switch.

3Additionally, connect the Colour Grading panel to the remote unit of the USB extender kit.

4Use a network cable to connect an available port on the Netgear network switch to the workstation’s on-board GigE port 1, as illustrated.

Connecting the Slave Renderer to a Lustre Workstation

The Lustre Slave Renderer is a single render node that provides automatic background rendering on a shot-by-shot basis. It is available for the Lustre Master Station, the Station, and the HD Station.

16 Chapter 3 Connecting Peripherals