HP Z800 manual Connecting the Autodesk Control Surface, Lustre Workstation

Connect the GigE adapter as follows:

■SAN

■Private and/or dedicated Wire network

■Link aggregation ( port bonding) switch, etc.

Connect the optional Qlogic DDR InfiniBand adapter as follows:

■Port one (right-most port) to InfiniBand network switch

For information on network configuration see the Autodesk Visual Effects and Finishing Installation and Configuration Guide.

Lustre Workstation

As you make the GigE network connections, be sure to take note of the port numbers used. You will need these later, when configuring the network.

Connect the built-in GigE ports as follows:

■House network in port 0.

■Autodesk Control Surface (via network switch) in port 1

Connect the GigE adapter as follows:

■SAN

■Private and/or dedicated Wire network

■Incinerator private network. For more information, see the Autodesk Incinerator Installation and User Guide.

Connect the optional Qlogic DDR InfiniBand adapter as follows:

■Port one (right-most port) to InfiniBand network switch. This port is also used by Incinerator, to transfer frames.

For information on network configuration, see the Autodesk Lustre Installation Guide for Linux Workstations and/or Autodesk Lustre User Guide.

Connecting the Autodesk Control Surface

The Autodesk Control Surface consists of three panels connected to the workstation’s on-board GigE port 1 by way of the supplied network switch. The central panel requires an additional connection to the remote unit of the USB extender kit.

NOTE This section does not apply to Autodesk Visual Effects and Finishing applications.

This section provides information on making the physical connections needed to operate the Autodesk Control Surface. For configuration information, see Configuring the Autodesk Control Surface. For user information, see the Autodesk Control Surface User Guide.

Lustre Workstation 15