HP Vectra VL 6 manual Replacing the Pentium II Processor

Page 12

Installing Accessories in the New Desktop Package

Replacing the Pentium II Processor

The Pentium II processor is contained on a module which is installed in a socket on the system board. It is held in place by a bracket. There are two plastic clips, one on the top of each pillar of the bracket, to prevent the processor module from slipping out.

Plastic clips

Bracket pillars

Heat-sink

To remove the old processor module:

1Press the two plastic clips towards each other.

2Carefully pull the processor module away from its connector on the system board.

The heat-sink is supplied with the processor, and is bolted to it by the manufacturer.

10

Image 12

Contents Familiarization Guide Hewlett-Packard Company Manually switched 115/230 VAC Vectra Products ComparisonVolt Voltage Regulator Module New Package for the Desktop Models Rear viewMinitower Package System Board and Backplanes Desktop front view Desktop rear viewMinitower top view Installing Accessories in the New Desktop Package Removing the Power SupplyRemoving the Cover Installing an Accessory Board Installing a Hard Disk Drive in the Top Rear Shelf Installing a Hard Disk Drive in the Bottom Rear ShelfInstalling a CD-ROM Drive or Zip Drive in a Front Shelf Unit forward about half wayReplacing the Pentium II Processor Replacing the System Board Accessories that are Supplied with the PC Matrox Millennium Graphics Controller BoardFlashing the Latest Version of the System Bios Access HP World Wide Web SiteComplete the Questionnaire to Check Your Understanding New drive will already have the correct front bezelComplete the Questionnaire to Check Your Understanding Answers and Explanations Answers and Explanations 50%