HP Vectra VL 6 manual Replacing the System Board

Page 13

Installing Accessories in the New Desktop Package

Replacing the Flexible Disk Drive

The flexible disk drive is mounted vertically in the front, right-hand edge of the computer. It is held in place by two plastic clips, one visible from above, and the other visible through a square hole in the right-hand bottom panel of the computer.

Replacing the System Board

Flexible disk drive

Plastic clips

To remove the flexible disk drive, press both plastic clips leftward, and pull the drive out through the front of the computer.

To install the new processor module, reverse the above procedure.

The system board is secured in place by the familiar system board handle mechanism. However, before the system board can be removed, it is necessary first to remove the left-hand bottom panel of the computer. This is held in place by a metal clip at the front end, and can be released by levering it at this end with a screw-driver, or similar implement.

Once the replacement system board has been installed, reverse the above procedure. Insert the back end of the left-hand bottom panel into its slots in the back panel of the computer, and then push the front end until it clips into place.

11

Image 13
Contents Familiarization Guide Hewlett-Packard Company Vectra Products Comparison Manually switched 115/230 VACVolt Voltage Regulator Module Rear view New Package for the Desktop ModelsMinitower Package System Board and Backplanes Desktop rear view Desktop front viewMinitower top view Removing the Power Supply Installing Accessories in the New Desktop PackageRemoving the Cover Installing an Accessory Board Installing a Hard Disk Drive in the Bottom Rear Shelf Installing a Hard Disk Drive in the Top Rear ShelfUnit forward about half way Installing a CD-ROM Drive or Zip Drive in a Front ShelfReplacing the Pentium II Processor Replacing the System Board Matrox Millennium Graphics Controller Board Accessories that are Supplied with the PCAccess HP World Wide Web Site Flashing the Latest Version of the System BiosNew drive will already have the correct front bezel Complete the Questionnaire to Check Your UnderstandingComplete the Questionnaire to Check Your Understanding Answers and Explanations Answers and Explanations 50%