HP Vectra VL 6 manual Installing Accessories in the New Desktop Package, Removing the Cover

Page 8

Installing Accessories in the New Desktop Package

Installing Accessories in the New Desktop Package

The new package for the desktop models involves a number of new procedures.

Removing the Cover

3. Unlock with the key

1. Press the

2. Press the two tabs down, pivot

latch down

the panel downward, and lift it off

4.Push the cover away from you and lift off

Removing the Power

Supply

1. Remove all external cables

2. Lift the front of the power supply to free the two side catches

3. Slide it horizontally out

4. Lift the power supply clear and lay it upside down on the

 

front drive unit

6

Image 8
Contents Familiarization Guide Hewlett-Packard Company Volt Voltage Regulator Module Manually switched 115/230 VACVectra Products Comparison New Package for the Desktop Models Rear viewMinitower Package System Board and Backplanes Minitower top view Desktop front viewDesktop rear view Removing the Cover Installing Accessories in the New Desktop PackageRemoving the Power Supply Installing an Accessory Board Installing a Hard Disk Drive in the Top Rear Shelf Installing a Hard Disk Drive in the Bottom Rear ShelfInstalling a CD-ROM Drive or Zip Drive in a Front Shelf Unit forward about half wayReplacing the Pentium II Processor Replacing the System Board Accessories that are Supplied with the PC Matrox Millennium Graphics Controller BoardFlashing the Latest Version of the System Bios Access HP World Wide Web SiteComplete the Questionnaire to Check Your Understanding New drive will already have the correct front bezelComplete the Questionnaire to Check Your Understanding Answers and Explanations Answers and Explanations 50%