QuickSpecs
HP Compaq 8000 Elite PC
Technical Specifications - Environmental Data
External:
Corrugated Carton 1362 g
Corrugated 343 g Internal:
EPE - Expanded Polyethylene 198 g
Polyethylene low density foam 39 g
The Corrugated Carton packaging material is made from 75% recycled content. The EPE - Expanded Polyethylene packaging material is made from 100% recycled content.
The Polyethylene low density foam packaging material is made from 100% recycled content.
Convertible Minitower
Energy Consumption | 115 VAC | 230 VAC | 100 VAC |
(typically configured) |
|
|
|
Normal Operation | 42.224 W | 42.076 W | 42.366 W |
Sleep (Energy Star low | 2.962 W | 2.886 W | 2.894 W |
power mode) |
|
|
|
Off | 0.646 W | 0.802 W | 0.652 W |
Heat Dissipation* | 115 VAC | 230 VAC | 100 VAC |
Normal Operation | 144 BTU/hr | 144 BTU/hr | 145 BTU/hr |
Sleep | 10 BTU/hr | 10 BTU/hr | 10 BTU/hr |
Off | 2 BTU/hr | 3 BTU/hr | 2 BTU/hr |
*Heat dissipation is calculated based on the measured watts, assuming the service level is attained for one hour.
Declared Noise Emissions
(in accordance with ISO 7779 and ISO 9296)
| Sound Power | Sound Pressure |
System Fan Off | (LWAd, bels) | (LpAm, decibels) |
Idle | 3.8 | 28 |
Fixed Disk | 3.8 | 28 |
(random writes) |
|
|
Batteries | This battery(s) in this product comply with EU Directive 2006/66/EC | |
Batteries used in the product do not contain:
Mercury greater the 5ppm by weight
Cadmium greater than 10ppm by weight
Battery size: CR2032 (coin cell)
Battery type: Lithium
Additional Information 
This product is in compliance with the Restrictions of Hazardous Substances (RoHS) directive - 2002/95/EC.
This HP product is designed to comply with the Waste Electrical and Electronic Equipment (WEEE) Directive - 2002/96/EC.
This product is in compliance with California Proposition 65 (State of California; Safe Drinking Water and Toxic Enforcement Act of 1986).
This product is in compliance with the IEEE 1680 (EPEAT) standard at the Gold where HP registers commercial desktop products. See http://www.epeat.net for registration status in your country.
Plastics parts weighing over 25 grams used in the product are marked per ISO 11469 and
DA - 13424 Worldwide QuickSpecs — Version 17 — 6/25/2010 | Page 60 |