HP 8000 manual DDR3 Synchronous Dram NON-ECC System Memory, Ultra-slim Desktop

QuickSpecs

HP Compaq 8000 Elite PC

Standard Features and Configurable Components (availability may vary by country)

DDR3 Synchronous DRAM NON-ECC System Memory

Memory upgrades are accomplished by adding single or multiple DIMMs of the same or varied sizes. This chart does not represent all possible memory configurations. The HP Compaq 8000 Elite Series PC supports non-ECC DDR3 PC3-10600 (1333 MHz) and PC3-8500 (1066 MHz) memory.

CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules. Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged in to an active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system board.

Ultra-slim Desktop

Maximum Memory* Supports up to 8 GB of DDR3 SDRAM using SO-DIMM modules. Slot 1 is black and must always be populated. Not all memory configurations possible are represented below.

NOTE: For systems configured with more than 3 GB of memory and a 32-bit operating system, all memory may not be available due to system resource requirements.

SO-DIMM Size		Slot
	Channel A (black)		Channel B (white)
1 GB	1 GB
2 GB	1 GB		1 GB
(dual channel symmetric)
4 GB	2 GB		2 GB
(dual channel symmetric)
8 GB	4 GB		4 GB
(dual channel symmetric)

*The Intel Q45 Express chipset includes a built-in Management Engine (ME), which allocates memory for manageability functions. Management Engine memory is shared with system memory. If the PC contains a single SO-DIMM, 16 MB of memory is pre-allocated for it at system startup. If the PC contains two SO-DIMMs, 32 MB of memory is pre-allocated. This memory is not made available to the operating system, just as pre-allocated video memory is not available.

Small Form Factor and Convertible Minitower

Maximum Memory*	Supports up to 16 GB of DDR3 SDRAM using DIMM modules. Slot 1 is black and must
	always be populated. Not all memory configurations possible are represented below.
	NOTE: For systems configured with more than 3 GB of memory and a 32-bit operating
	system, all memory may not be available due to system resource requirements. Addressing
	memory above 4 GB requires a 64-bit operating system.

DA - 13424 Worldwide QuickSpecs — Version 17 — 6/25/2010 Page 9