3.Lift the rear edge of the hard drive cover, and then swing it up and forward.
4.Remove the hard drive cover.
NOTE: The hard drive cover is included in the Plastics Kit, spare part number
5.Grasp the Mylar tab on the hard drive and slide the hard drive (1) to the left to disconnect it from the system board.
6.Remove the hard drive (2) from the hard drive bay.
7.If it is necessary to remove the hard drive shield, remove the two Phillips PM3.0×3.0 hard drive shield screws (1) from each side of the hard drive.
42 Chapter 4 Removal and replacement procedures | ENWW |