USB/Card Reader board
Description | Spare part number |
|
|
USB/Card Reader board | |
|
|
Before removing the USB/Card Reader board, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power cord.
4.Remove the battery (see Battery on page 39).
5.Remove the following components:
a.Hard drive (see Hard drive on page 41)
b.Top cover (see Top cover on page 55)
c.Keyboard (see Keyboard on page 57)
d.Display assembly (see Display assembly on page 62)
e.System board (see System board on page 67)
Remove the USB/Card Reader board:
1.Turn the system board upside down with the rear toward you..
2.Slide the USB/Card Reader board (1) away from the system board to disconnect the two multipin connectors (2).
Reverse this procedure to install the USB/Card Reader board.
78 Chapter 4 Removal and replacement procedures | ENWW |