13.Disconnect the display panel cable (2) from the system board.
14.Release the tape (1) that secures the WWAN antenna cables to the system board.
15.Release the grounding tape (2) that grounds the WWAN antenna cables to the base enclosure.
16.Release the WWAN antenna cables (3) from the opening in the system board.
CAUTION: Support the display assembly when removing the following screws. Failure to support the display assembly can result in damage to the display assembly and other computer components.
17.Remove the four Phillips PM2.5×6.0 screws (1) that secure the display assembly to the computer.
ENWW | Component replacement procedures 65 |