HP 2113AH, 2186AF, 2182US, 2182AT, 2182AF Russia International, PTC200 7.5.2 3 4 Ringer Sensitivity

Page 114

Reference Information

Regulatory Information

PTC200 7.5.2 (3) (4) Ringer Sensitivity

This device may be subject to ringing or bell tinkle when certain other devices are connected to the same line. If this occurs, the problem should not be referred to the Telecom Faults Service.

Associated Software Limits of Compliance

Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the application software or PC equipment associated with this device. The application software shall be set to operate within the following limits for compliance with Telecom’s specifications:

The S0 register must contain a value of 0 for no auto-answer or a value of 2 for auto-answer.

The S6 register must contain a value of 2, 3, 4, 5, 6, or 7. The factory default of 2 is recommended. The S7 register must contain a value less than 90. The factory default of 72 is recommended.

The S10 register must contain a value less than 150. The factory default of 14 is recommended. The S11 register must contain a value greater than 60. The factory default of 95 is recommended.

There shall be no more than 10 call attempts to the same number within any 30-minute period for any single manual call initiation.

The equipment shall go on-hook for a period of not less than 30 seconds between the end of one call attempt and the beginning of the next attempt to the same number.

Automatic calls to different numbers shall be not less than 2 seconds apart.

Failure to set these parameters correctly could negate the User Rights under the Telecom Terms of Service.

Russia

	International
	Products sold internationally by the manufacturer and its authorized dealers meet the
	specifications listed on the following page.

Note	For regulatory identification purposes, your product is assigned a Regulatory
	Model Number. The Regulatory Model Number for your product is listed in the
	declaration below. This regulatory number is different from the marketing name
	and product number.

108 Reference Guide

Image 114

Contents Compaq Notebook Series Reference Guide Ii Reference Guide Important Safety Information Software Product License Agreement Iv Reference GuideReference Guide Vi Reference Guide Contents Batteries and Power Management Index Getting Started with Your Notebook Identifying Parts of the Notebook Series 2100 and N1050vIdentifying Parts of the Notebook Mini-PCI cover no user parts inside Series Identifying Parts of the Notebook Identifying Parts of the Notebook Status Lights Power modeBattery status Hard disk drive activityIdentifying Parts of the Notebook Setting Up Your Notebook Insert the batteryConnect AC power Connect a phone line Set up Windows Turn on the notebookHint Basic Operation Standby -Power Default power settingsPower mode To enter this mode Function Operating Your NotebookTo reset the notebook To change the boot deviceTo use the TouchPad To use the function hot keys This hot key Does thisTo use the One-Touch buttons To program a One-Touch buttonTo use the Windows and Applications keys To use the ALT GR keyThis key combination Does this Using CDs or DVDs Could stop responding and you could lose dataTo play DVD movies To create or copy CDsTo lock your notebook To set up password protectionSecuring Your Notebook WindowsTo attach a security cable To protect against virusesTo lock the hard disk drive Hard disk driveTaking Care of Your Notebook To protect your hard disk driveTo maintain your notebook To safeguard your data To clean your notebookTo extend the life of the display Batteries and Power Management Managing Power Consumption How the notebook manages power automaticallyInformation that was not saved will be lost Changing timeout settings and creating power schemes Unsaved data if the notebook battery runs down completelyUsing Battery Power To check battery statusTo respond to a low-battery warning To recharge the battery To get the most from your batteriesUsing Battery Power Modem and Network Connections Using the Modem Telephone line type prior to connecting your phone lineTo change your modem settings Special restrictions in certain countriesConnecting to a Local Area Network LAN Making Wireless Network Connections select models only Connecting to an Existing Wireless NetworkTo prepare for connections Creating a New Notebook-to-Notebook Network Ad Hoc Purchase a license before using the wireless function Individual wireless functionsTurning on communication and making a connection Turning off communication and ending a connection Turning on Bluetooth communication Making Wireless Bluetooth Connections select models onlyTo turn Bluetooth communication on and off FunctionTo prepare for Bluetooth connections Turning off Bluetooth communicationTo send or receive files using Bluetooth Sharing files with another Bluetooth device FTPSending Outlook data to another Bluetooth device OPP Add-On Devices Connecting External Devices Connecting PC Cards To insert or remove a PC CardInserting a PC Card Connecting External Devices These jacks may damage the notebook Series 2100 and N1050v External microphone connector pinkAudio recorder ReplicatorAdjusting monitor resolution and other settings Connecting an external monitorSwitching the display to the external monitor To use an external monitorUsing dual display mode To connect an Ieee 1394 device select models onlyPrinting to an infrared printer Using the infrared portTo connect an infrared device select models only Transferring files through an infrared connectionTo use a port replicator select models only To dock to the port replicator To undock from the port replicator Installing Additional RAM Memory To install a RAM expansion moduleBack of the notebook Series 2100 To remove a RAM expansion module Installing Additional RAM Memory Replacing the Hard Disk Drive To replace the hard disk driveTo replace the hard disk drive holder To prepare a new hard disk drive Troubleshooting and Maintenance If no sound is audible Troubleshooting Your NotebookAudio problems If sound does not recordIf you get a Region Code error when playing a DVD movie CD-ROM and DVD problemsIf you can’t boot from a CD or DVD If a DVD plays erraticallyDisplay problems If the notebook hard drive doesn’t spin Hard disk drive problemsIf an external display does not work If the hard disk makes a buzzing or whining noiseIf you have problems with infrared communications Heat problemsInfrared problems If the notebook gets abnormally hotIf the TouchPad doesn’t work Keyboard and pointing device problemsIf the pointer is difficult to control If the TouchPad moves the pointer or cursor while you typeIf you can’t log in to Netware servers Local area network LAN problemsIf the built-in network adapter doesn’t connect to the LAN If a network connection responds slowlyMemory problems Modem problemsIf the modem dials but doesn’t connect If the modem doesn’t dial or no dial tone is detectedIf the modem dials incorrectly If the modem isn’t detectedIf the modem connects, but transferred data is bad If the modem causes an Error messageIf the modem dials but you can’t hear it If the modem doesn’t faxPC Card Pcmcia problems Performance problemsIf the notebook turns off immediately after it turns on Power and battery problemsIf the notebook stops responding If the notebook keeps beepingIf the battery doesn’t charge If the Time Remaining for the battery is not correctIf the notebook has a short operating time Printing problems If a serial modem doesn’t work properly Serial, parallel, and USB problemsIf a serial mouse doesn’t work If the serial or parallel port is not workingStartup problems Wireless problems If you have problems with wireless 802.11 communicationIf your notebook cannot detect any Bluetooth devices If your notebook cannot detect a certain Bluetooth deviceIf you can connect, but the network is slow Configuring the Notebook To run the Bios Setup utilitySetting Description Default Main MenuSecurity Menu To change video memory settings using Bios Setup utility Reinstalling and Updating Software To replace a damaged QuickRestore System Recovery CDReference Information Command Conexant Modem Reference InformationModem Reference Conexant G ,h ,i G,h +MCR ECC Commands AT* Commands +FMRRegister Function Conexant Range/units Default Code MeaningSafety Information Power CordsCountry or Region Rated Voltage and Current Battery Safety Laser SafetyLED Safety Mercury SafetyExposure to Radio Frequency Radiation Regulatory Information Connections to Peripheral DevicesRegulatory Information Responsible Party CanadaDeclaration of Conformity U.S.A Trade nameEuropean Union Regulatory Information Japan Japan Telecommunications ApprovalNew Zealand Conexant AMC20493-KT5 Data Fax Modem PTC 211/02/071Russia International PTC200 7.5.2 3 4 Ringer SensitivityEMC Index QuickRestore System Recovery USB

Related manuals

Manual 188 pages 48.25 Kb

Manual 8 pages 26.72 Kb

Manual 118 pages 11.14 Kb

Manual 154 pages 13.11 Kb

Manual 14 pages 60.01 Kb

Manual 14 pages 56.44 Kb

Manual 126 pages 50.72 Kb