HP 2510AH, 2186AF, 2182US Modem Reference Information, Modem Reference Conexant, Command Conexant

Reference Information

Modem Reference Information

Modem Reference Information

	You can customize the operation of the modem using AT commands and S-registers.
	You can do this from Phone and Modem Options in Control Panel, from most
	communications software, or by using terminal mode in your software.
Note	You should have a good understanding of modems and how they operate before you
	change default settings.
	This section contains summary information about AT commands, S-registers, and
	selected result codes for the built-in modem.

	Modem Reference (Conexant)
	All listed AT commands must be preceded by the characters “AT” (except for the
	command “A/”). The commands can be entered in upper or lower case. Many
	commands can be used as queries by entering “?” as the argument.
	Conexant AT Commands (Advanced Users Only)
Command	(Conexant)
A	Go off-hook and attempt to answer a call.
A/	Re-execute command (not preceded by AT).
Dn	Dial modifier: 0–9, A–D =DTMF digits; L=redial last number; P=pulse dialing; T=tone dialing;
	W=wait for dial tone; * (“star”); # (“pound sign”); +; !=flash; @=wait for silence; $ or &=wait for credit
	card dialing tone; ;=return to command state; ‘=dial pause; ^=toggle calling tone. Parentheses,
	hyphens, and spaces can be used to format dial string and have no other effect.
E0	Turn off command echo.
E1	Turn on command echo (default).
H0	Initiate hang-up sequence.
H1	If on-hook, go off-hook and enter command mode.
I0	Report product code.
I1	Report LSB of stored checksum.
I2	Report “OK”.
I3	Report identification codes.
I4	Report product description.
I5	Report country code parameter.
I6	Report modem data pump model and internal code revision.
I7	Report modem data pump model and internal code revision.
I8	Report “OK”.
I9	Report country.
Ln	Set speaker volume: 0=off, 1=low (default), 2=medium, 3=high.
Mn	Activate speaker: 0=off, 1=on during handshaking and off when receiving carrier (default), 2=always
	on, 3=off when dialing and receiving carrier, on when answering.
N0 or N1	Included for compatibility only; returns result code.

90 Reference Guide