HP A3644A, A2969A manual Configure the Operating System and the Adapter, Verm Operation

Page 34

Configure the Operating System and the Adapter

The HP-HSC Fast/Wide Differential SCSIadapter should au&xonfigure into supported HP-UX systems. When the operating system reboots it will determine your adapter has been installed and will install the correct software device files necessary for the operating system to communicate with peripherals connected to the adapter.

Verm Operation

The only indication of proper operation on the adapter is the green TERM POWER LED located on the adapter bulkhead. If this LED is on, it indicates the adapter is supplying termination power to the SCSIbus.

If the TERM POWER LED is off, refer to the Service Information chapter of this manual for help.

If the TERM POWERLED is on but the SCSIdevice connected to the adapter does not operate properly and you suspect the adapter is malfunctioning, refer to the Service Information chapter of this manual for help.

34InstallationRocedures

Image 34

Contents III’ A2969NA36M HP-HSC FastlWide Diffkrentid Scsi Adapt,ers Edition March Regulatory Statements About This Book Table of Contents Service Information Reference HP-HSC Fast/Wide Differential Scsi A2969AX Product ContentsDescription Scsi Termhator Al65862024Power 75 W @ 5.OV Consumptior SpecificationsSupported HP A2969A At 40C 104F 5C to 40C 4oc to 70C 41*F to 104F15%to 84E-G 15%to 95% Km 15,000 ftInstallation Procedures Installation Overview Prepare to Install the Adapter Verify Product ContentsRecord Adapter Information Shut Down the Operating System and Switch Off the Computer Set Scsi Adapter DIP Switches ? L Numbers on Printed-Circuit Card II klldMLlRRAR rll-OPENl If Necessary, Remove the Termination ResistorsInstall the Adapter Install the HP A2969A Scsi Adapter in an HP 9000 Series Kxxx Slot covers Installation Procedures Install the HP A3644A Scsi Adapter in an HP 9000 Series T6xx HP-H!3C I/O bus converter Removing a cover blank Installing the HP A3644A card Instalition Procedures Page Connect Cable and Peripheral Devices Scsi Cable ConnectionConnecting cables to the computer InstaUationAocedmes Peripheral Device Connections Only the two ends of a Scsi bus should be terminated Terminate the Scsi BusProper operation on the Scsi bus Switch Power on to Peripherals, then to the Computer Configure the Operating System and the Adapter Verm OperationService Information Field Replaceable Units Troubleshooting Tools Replacing the Term Power Fuse Term power fuse location Service informationInstalling a replacement fuse Selvice Information Mapper Iotest Removal/Replacement Instructions Reshipment Guidelines 44serviceInformation Glossary SmaUlight emitting device used to provide status information Scsi ID Page Install the adapter Bus arbitrationInstallation Verify proper operation Index Title Company Address City & State Company Learning Products MS5668Tape Copyright Hewlett-Packard Company A2969-96002