HP 3Com Etherlink III 3C590 manual Microsoft Windows NT 4.0 Workstation

5 Installing the 3COM Etherlink III 3C590 PCI 10BT Network Adapter

Microsoft Windows NT 4.0 Workstation

5Installing the 3COM Etherlink III 3C590 PCI 10BT Network Adapter

Microsoft Windows NT 4.0 Workstation

Connecting to a Windows NT 3.51 Server

Requirements

•HP Vectra with Windows NT 4.0 Workstation.

•3COM Etherlink III 3C590 PCI 10BT network adapter and driver disk ver- sion 5.2.2.

•Driver File: EL59X.SYS, version 1.22

•Microsoft Windows NT 4.0 Workstation media.

•Microsoft Windows NT 4.0 Service Pack 4.

•Microsoft Windows NT 3.51 Server system that supports NetBEUI, NWLink IPX/SPX Compatible Transport and NWLink NetBIOS network protocols.

Device Configuration

Device Configuration	Vectra Vli8	Vectra VEi7	Vectra VEi8
Interrupt	11	03	10
I/O Address	1020	DCE0	E400

Procedure

1With the HP Vectra turned off, install the 3COM 3C590 network adapter into a PCI slot.

2Connect network cable media to the 3COM 3C590 network adapter.

3Log onto Windows NT4 Workstation with administrator privileges (Contact your network administrator if you do not have the required information).

4Right-click on the “Network Neighborhood” icon and select “Properties”.

5Click on “Yes” when prompted to install Windows NT Networking.

6Select “Wired to the network” and click on “Next”.

7Click on the “Select from list…” button and then the “Have Disk…” button.