HP 2000, D1E80UA manual Optical drive connector cable

Remove the speakers:

1.Disconnect the speaker cable (1) from the system board.

2.Release the speaker cables (2) from the clips built into the base enclosure. Remove the Phillips PM2.5×9.0 screw (3) and the three Phillips PM2.5×6.0 screws (4) that secure the speakers to the computer. Remove the speakers (5).

Reverse this procedure to install the speakers.

Optical drive connector cable

NOTE: The optical drive connector cable is included in the Cable Kit, spare part number 646119-001.

Before removing the optical drive connector cable, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 39), and then remove the following components:

●Optical drive (see Optical drive (select models only) on page 40)

●Keyboard (see Keyboard on page 49)

●Top cover (see Top cover on page 51)

Component replacement procedures 61