10.Display assembly (see Display assembly on page 63)
11.Power connector (see Power connector on page 62) Remove the optical drive connector board:
1.Turn the computer
2.Remove the three Phillips 4.0 x 2.5 screws (1) that secure the optical drive connector board to the computer.
3.Move the optical drive connector board (2) to the right, and then lift it up to disconnect it from the system board.
Reverse this procedure to install the optical drive connector board.
4.Remove the three Phillips 3.0 x 2.0 screws (1) that secure the system board to the computer.
70 | Chapter 4 Removal and replacement procedures |