Roberts Gorden BH-200 Heater Safety, Manpower Requirements, Safety Labels and Their Placement

Page 7

SECTION 1: HEATER SAFETY

SECTION 1: HEATER SAFETY

Your Safety is Important to Us! This symbol is used throughout the manual to notify you of possible fire, electrical or burn hazards. Please pay special attention when reading and

following the warnings in these sections.

Installation, service and annual inspection of heater must be done by a contractor qualified in the installation and service of gas-fired heating equipment.

Read this manual carefully before installation, operation or service of this equipment.

This heater is designed for heating nonresidential indoor spaces. Do not install in residential spaces. These instructions, the layout drawing, local codes and ordinances, and applicable standards that apply to gas piping, electrical wiring, venting, etc. must be thoroughly understood before proceeding with the installation. Protective gear is to be worn during installation, operation and service. Thin sheet metal parts, such as the reflector portion of the heater and the various venting components, have sharp edges. To prevent injury, the use of work gloves is recommended. The use of gloves will also

prevent the transfer of body oils from the hands to the surface of the reflector.

Before installation, check that local distribution conditions, nature of gas and pressure, and adjustment of the appliance are compatible.

For additional copies of the GORDONRAY® BH Installation, Operation and Service Manual, please contact Roberts-Gordon LLC.

1.1 Manpower Requirements

To prevent personal injury and damage to the heater, two persons will be required for installation.

1.2 Safety Labels and Their Placement

Product safety signs or labels should be replaced by the product user when they are no longer legible. Please contact Roberts-Gordon or your ROBERTS GORDON® independent distributor to obtain replacement signs or

labels. See Page 1, Figure 1through Page 2, Figure 2.

FIGURE 1: Top and Bottom Panel Label Placement

 

 

Gas Connection Label

 

Top Panel

 

 

 

Vent Length Label

 

 

Logo Label

Description

Part Number

 

Logo Label

91031100

 

Vent Length Label

91039500

 

Gas Connection Label

91018123

Bottom Panel

 

 

 

 

1

Image 7
Contents Open windows These instructions prior to any installationInstaller must give a copy of this manual to the owner Manual thoroughly before installing or servicingPage Roberts-Gordon LLC Page Table of Figures Page Manpower Requirements Heater SafetySafety Labels and Their Placement Side and Back Panel Label Placement Wall Tag Installer ResponsibilityNational Standards and Applicable Codes Maintain clearances to combustibles at all times for safety Model InchesC D CentimetersTube, Standard Reflector Model 45 Tilt Reflector ModelInches Centimeters Tube, Opposite 45 Reflector ModelCentimeters Model Venting InchesNational Standards and Applicable Codes Major Components Contents of BH-Series Burner Carton Standard Parts ListContents of Core and Extension Packages BH-Series Component Package Guide Heater Installation Typical Suspension Details
Related manuals
Manual 70 pages 23.9 Kb Manual 70 pages 6.75 Kb