Hard Disk Drive
(End User Replaceable)
The Hard Disk Drive Module is user replaceable.
Caution: Handle the hard disk drive only by its edges to avoid damage from electrostatic discharge.
To remove the Hard Disk Drive Module, remove the screw under the latch on the hard drive. Push the Hard Drive Module Forward - do not pull on the latch - it is not strong enough, use the back edge of the module in front of the depression in the bottom case instead.
Reverse the procedure for installation. To ensure proper pin placement, hold the Hard Disk Drive by the sides, being careful not to touch the pins. Turn the OmniBook on its backplane (where all the ports are) and place the hard drive into the slot and allow gravity to drop the drive down the remaining distance into the slot. The pins will line up and a small push thereafter will ensure it is seated correctly.
Figure 3 - Hard Disk Drive
27