HP 5000C/CT manual Icon Assembly and Display Module, HP Authorized Service Providers Only

Page 29

Icon Assembly and Display Module

(HP Authorized Service Providers Only)

To remove the display module and/or Icon Assembly on the OmniBook 5000C, CT, and CTS turn the unit over, raise the feet, and withdraw the two Phillips screws from under the feet in the bottom back corners of the unit (see illustration below).

Display/Chassis

Screw (2)

Figure 4 - Display Screws

Turn the unit right side up and dislodge the Icon assembly by placing the thumbs on each edge of the assembly and pushing lightly (see illustration below). The front edge of the Icon Assembly will lift up slightly

29

Image 29

Contents Familiarization Guide HP OmniBook 5000C/CTPage Table of Contents Disk Configuration Memory Door and Slot Table of FiguresOmniBook Product Comparisons Mass Storage HP OmniBook PowerRemovable Modules Ports HP OmniBook AudioSecurity Pre-installed SoftwareHP OmniBook Expandability Product Description Part Number OmniBook 5000 Series Product FeaturesModels Product Description Part Number Product Description Part Number OmniBook 5000 enhancements over the OmniBook Accessories Description Part NumberSlots BoxPossible Memory Memory Slot Total RAM Configurations HDD IBM Hard Drive 540MB 810 MB 215MBBuilt-in I/O Flexible disk driveDisplay/Video Resolution Maximum colorsUser interface 16MB, VGA, Dstn Management standard ApproxCharger Operating TestingEnvironment Storage environmentSystems Password DecodeSupported Operating Password Decode Policy Field Replaceable Assemblies Installing memory Battery Module and Floppy Disk Drive Module Hard Disk Drive Small parts HP Authorized Service Providers Only Icon Assembly and Display ModuleIcon Assembly Display Removal Palm Rest Assembly and Track Ball Assembly To replace, reverse the above procedure Keyboard and Power Board Keyboard Assembly and Power Board PCB Assy DC Power PI-DCComponents to remove prior to Upper Cover Upper Cover Assembly and Icon Board PCB Assy PI-ICONHeat Pipe Replacement Procedure HP Authorized Support Providers Only CPU Module and Heat SinkCPU Module and Heat Sink System Board PCB Assy PI-586 Standoff 11.75 mm Main Configuration Screen Configuration and SetupPower Control Screen Power ScreenSetting Parameters Default Comments Power ConfigurationSystem Configuration COM1,COM4 IRQ Input/Output ConfigurationInput/Output Screen Disk Configuration First Post Beep Codes Troubleshooting and RepairOmniBook Self-Test Beep Code Description System halt Display Codes Last PostMessage Possible Cause PhoenixBIOS Post Messages Power On Self TestPOST. Pressing the Fl key allows the system to Description HP Part Number Exchange Part Appendix a Part NumbersSUB Battery SET